symone

Hi Team,

I used Maxidas for scanning my GX470 05 and i have bellow erreur code.

C1336

Somebody knows how to resolve it ?

Thank You for your support

RCsGX

C1336/39
-Zero point calibration of deceleration sensor undone

-Yaw rate and deceleration sensor

-Zero point calibration undone

-Park/Neutral position switch (P position) circuit

See attached PDF....

symone

Thank you ! I will try to resolve as proposed

mann777

The Zero Point Calibration is only done under following circumstance.
1. Wheel Alignment has been adjusted
2. Any chassis component has been removed, installed or replaced
Basic Method
Disconnect the cable from the negative (–) battery terminal for MORE THAN two (2) seconds.
2. Reconnect the cable to the negative (–) battery terminal.
3. Perform the applicable zero point calibration of the yaw rate sensor and/or the steering angle
sensor. ( rotate Steering to the Left extreme and hold for 3 Seconds and then rotate to Extreme Right 3 Seconds and do this method for 3 cycle repeatedly.

mann777

The Zero Point Calibration Method if the basis one fails to solves . Check the attachment. Only you need to have the tool ( these are available off Amazon, Ebay for $30-50)

symone

thank you for this reply.

I will try to resolve it like you explain

Thank's again !

burny

keep us abreast

symone

Thankk you to all ! The issue is resolved !

burny

what did you do to resolve it Symone?