Which mounts are you using for your mobile phones?
09-25-12, 05:37 PM
#1
Which mounts are you using for your mobile phones?
Just curious. I have an iPhone 4S (Work) and a Galaxy Nexus (Personal) which I usually just dump into the cup holders, but I'm looking to move up to a proper mount. Would be nice to have a place to mount both phones.
Any suggestions, pictures, ideas, etc. would be greatly appreciated!
Cheers,
Kermee
Any suggestions, pictures, ideas, etc. would be greatly appreciated!
Cheers,
Kermee
09-25-12, 08:02 PM
#3
I used a
, with a
and a
mobile device holder. Parts total shipped was around $45.
Very sturdy mounting solution which occupies minimal space and positions the device up near the navigation screen. I don't have any pictures but you can get the idea from the amazon links. You do need to remove one wood grain molding strip from the side of the radio to install the Panavise mount.
Very sturdy mounting solution which occupies minimal space and positions the device up near the navigation screen. I don't have any pictures but you can get the idea from the amazon links. You do need to remove one wood grain molding strip from the side of the radio to install the Panavise mount.
Last edited by z0lt3c; 09-25-12 at 08:07 PM.
09-27-12, 11:47 AM
#5
Lexus Test Driver
There is a high probability that they might. However they are not the safest accessory. My rx was a show car and I did not have passengers really.
09-27-12, 12:50 PM
#6
I used a Panavise Custom InDash Mount, with a PanaVise 670-X T slot adapter and a Bracketron PHV-200-BL mobile device holder. Parts total shipped was around $45.
Very sturdy mounting solution which occupies minimal space and positions the device up near the navigation screen. I don't have any pictures but you can get the idea from the amazon links. You do need to remove one wood grain molding strip from the side of the radio to install the Panavise mount.
Very sturdy mounting solution which occupies minimal space and positions the device up near the navigation screen. I don't have any pictures but you can get the idea from the amazon links. You do need to remove one wood grain molding strip from the side of the radio to install the Panavise mount.
Since I have two phones, I may just do a combination of both mounts. Thanks again!
Cheers,
Kermee
Thread
Thread Starter
Forum
Replies
Last Post
