Earlier 470s & front axle replacement?
#34
#35
#36
Pit Crew
I used reman axles on my Toyota Previa 4trac. The job wasn't hard but the manual was an essential item. Any extra digital copies sent this way would also be much appreciated!
#37
dont even pay them to do that. You can do it all yourself with a common food injector and some worm driven smooth side clamps. Like these: http://www.mcmaster.com/#catalog/119/283/=llapf6 430 Ss Smooth-band Worm-drive Hose Clamp, 1-1/4" To 2" Clamp Dia Range, 3/8" Band Width
then get you some cv grease from your local auto parts store and a food injector with a plastic needle. Unclamp the boots and pack the grease into the food injector. Slide that plastic needle underneath the boot lip and squeeze all that grease back in there. It may take 2-3 injectors worth. Reclamp with new hose clamps.
Enjoy a beer. You just saved yourself hundreds in labor cost...all for 15 minutes of work.
then get you some cv grease from your local auto parts store and a food injector with a plastic needle. Unclamp the boots and pack the grease into the food injector. Slide that plastic needle underneath the boot lip and squeeze all that grease back in there. It may take 2-3 injectors worth. Reclamp with new hose clamps.
Enjoy a beer. You just saved yourself hundreds in labor cost...all for 15 minutes of work.
Thanks!
#38
Thanks!
#39
Pole Position
You're going to want to use the special CV joint grease. It's different.
Chip H.
Chip H.
#41
Driver School Candidate
Join Date: Dec 2010
Location: Texas
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Bauer26,
Could I get a copy of the manual mentioned in this thread? I've got to replace my 06 GX470 axles. Probably will go with the Cardones and repack and reboot my originals for back-up.
Thanks!
Could I get a copy of the manual mentioned in this thread? I've got to replace my 06 GX470 axles. Probably will go with the Cardones and repack and reboot my originals for back-up.
Thanks!
#42
Driver School Candidate
Join Date: Dec 2012
Location: KY
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Bauer26,
Just noticed my inside boot is split on my 07 with 85k on the clock. I've done the axle shafts on a BMW X5 but would be interested to see if i can get a copy of the manual mentioned in this thread.
I used the Cardone brand on the X5 - bought at Amazon. Had good luck with it.
Thanks!
Just noticed my inside boot is split on my 07 with 85k on the clock. I've done the axle shafts on a BMW X5 but would be interested to see if i can get a copy of the manual mentioned in this thread.
I used the Cardone brand on the X5 - bought at Amazon. Had good luck with it.
Thanks!
#43
Driver School Candidate
Axle part numbers needed
I have done quite a bit of searching here and Google trying to find part numbers for OEM FJ Cruiser front Axles to replace the ones on my GX. Does anyone happen to know the part numbers? Finding OEM parts online are usually about 25% cheaper than my local Toyota dealership. Any help would be much appreciated.
#45
Driver School Candidate
To anyone replacing their front CV Axles on 2003-2009 GX470s or 4Runners, here is a great youtube video showing the process in great detail. I will be performing this service in a week or so as my inner CV boots have been torn for an undisclosed amount of time and are no doubt in need of R&R after 185,000 miles on them. I am using Cardone 665235HD replacement parts, $150 for a pair of them shipped. I may reboot the OG parts if they do not appear too worn or have too much play.
Video:
Video:
Thread
Thread Starter
Forum
Replies
Last Post