DIY- IS350 steering wheel swap
#16
Pole Position
iTrader: (1)
Join Date: Aug 2014
Location: SoCal, Northridge 818,310,323,626
Posts: 302
Likes: 0
Received 4 Likes
on
4 Posts
After studying this, I got lost on the de-pinned wires (black and red), I understand you're splicing the black one with the long green one that you have, what about the red one? Are you splicing the red to the purple?
Around step 6 and 7, do I take these "modded" wires and splice them with the orange and yellow? Lol, holy shat I wanna do this but I think it's wayyyyy better to do a DIY YouTube vid versus guessing from the pix and cutting/soldering the wrong wires. Haha.
Around step 6 and 7, do I take these "modded" wires and splice them with the orange and yellow? Lol, holy shat I wanna do this but I think it's wayyyyy better to do a DIY YouTube vid versus guessing from the pix and cutting/soldering the wrong wires. Haha.
#17
Pole Position
Thread Starter
After studying this, I got lost on the de-pinned wires (black and red), I understand you're splicing the black one with the long green one that you have, what about the red one? Are you splicing the red to the purple?
Around step 6 and 7, do I take these "modded" wires and splice them with the orange and yellow? Lol, holy shat I wanna do this but I think it's wayyyyy better to do a DIY YouTube vid versus guessing from the pix and cutting/soldering the wrong wires. Haha.
Around step 6 and 7, do I take these "modded" wires and splice them with the orange and yellow? Lol, holy shat I wanna do this but I think it's wayyyyy better to do a DIY YouTube vid versus guessing from the pix and cutting/soldering the wrong wires. Haha.
#19
Pole Position
Thread Starter
#20
I know this is a super old thread, but anyone know if this process would work in the opposite order? Swapping a GS steering wheel to an IS and removing the paddleshifters? I would love to have the wood instead of an all leather steering wheel.
#21
Driver School Candidate
Join Date: Jan 2021
Location: Dorset
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Cruise control plug
I've just got a flappy paddle wheel to fit in my gs300. I was just checking the wiring to make sure it all matches before going ahead with the swap and noticed where you add the red wire into the cruise control plug I already have a wire there. Any idea what the wire is for and if it will still work? Do I need to swap that plug out for a different one or? Any advice would be very helpful. Ive attached a picture of the plug.
Thread
Thread Starter
Forum
Replies
Last Post
Evoaz92
GS - 4th Gen (2013-2020)
3
12-24-19 12:20 PM
Ling2IS
IS - 2nd Gen (2006-2013)
2
06-10-16 10:40 AM