Chrome door lock knob upgrade
09-17-11, 09:59 AM
#31
went to install mine today and realized I'd been shipped 4 for the drivers side, rather than 2 of each side. Of course, I realized this after removing the passenger front door. Bad on me for not checking the parts when they arrived months ago. Good news is the driver's side F&R went in no problem and removing/replacing my passenger front door panel got rid of a rattle that had been bugging me for 2 years when the door was shut.
I was able to reuse the red stickers by lifting them with a small knife from the corner and peeling them off the old *****.
I was able to reuse the red stickers by lifting them with a small knife from the corner and peeling them off the old *****.
03-08-12, 12:16 PM
#35
Pole Position
Join Date: Oct 2009
Location: CA
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Passnu2...I noticed that there is not a door liner removal DIY. What is involved in removing the door liner? I know there is a screw behind the plastic piece in the lock mechanism...any other screws? Thanks in advance.
03-08-12, 12:58 PM
#36
Will be adding a full DIY with pics, for now any thread that requires removal of the door panels will help you out. We should have something in the next week to post for everyone. You need to removal the entire door panel not just the plastic cup were the door handle is located.
Thread
Thread Starter
Forum
Replies
Last Post
acefalcon2
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
4
06-05-10 09:52 PM
