GS - 2nd Gen (1998-2005) Discussion about the second generation GS300, GS400 and GS430 (1998 - 2005)

odd problem

Thread Tools
 
Search this Thread
 
Old 08-08-13, 01:08 PM
  #1  
Echo419
Rookie
Thread Starter
iTrader: (1)
 
Echo419's Avatar
 
Join Date: Sep 2012
Location: Ga
Posts: 69
Likes: 0
Received 0 Likes on 0 Posts
Default odd problem

2002 GS430.

car will drive fine until all of the sudden it will lose power. power as in I'll press the pedal with little to no response. it will idle down(even while moving) then die or if I drop it into neutral it'll die right away. sometimes it'll start right back up but the last 2 times(about once a week or every 300 miles) it'll die but won't start until I let it sit for a few minutes. then it cranks right back up and drives fine. I should note when it does die and won't start back up that when this happens it'll turn over and crank but when the rpms come back down to idle after initial starting it goes straight down to die. instant on/off. crank-vroom-off.

I replaced the fuel pump and filter and checked all my vac hoses best I could. visually and with break cleaner to see if I could get an idle change while running.

Thoughts?
Old 08-08-13, 01:55 PM
  #2  
DosyBoy
Lexus Champion
iTrader: (1)
 
DosyBoy's Avatar
 
Join Date: Sep 2011
Location: PGH
Posts: 2,098
Likes: 0
Received 11 Likes on 9 Posts
Default

Hmmm maybe the oil control valve?
Old 08-09-13, 07:59 AM
  #3  
Debonair
iModerate
 
Debonair's Avatar
 
Join Date: May 2007
Location: 408 NOR CAL
Posts: 3,397
Received 39 Likes on 27 Posts
Default

Does the check engine light come on? Have you had the car scanned for Diagnostic Trouble Codes?
Old 08-10-13, 01:17 PM
  #4  
Echo419
Rookie
Thread Starter
iTrader: (1)
 
Echo419's Avatar
 
Join Date: Sep 2012
Location: Ga
Posts: 69
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by FlockoGS4
Hmmm maybe the oil control valve?
Oil control valve?
Originally Posted by Debonair
Does the check engine light come on? Have you had the car scanned for Diagnostic Trouble Codes?
No cel until last night on the way home. It didn't appear to effect the car until this afternoon. Now it won't start. Still cracks but dies instantly. Towing it to the shop and going to check this cel. Anyone think it could be O2 sensor?
Old 08-11-13, 07:34 PM
  #5  
GS4_Fiend
Lexus Test Driver
iTrader: (22)
 
GS4_Fiend's Avatar
 
Join Date: Aug 2008
Location: CA
Posts: 7,015
Received 86 Likes on 69 Posts
Default

Sounds like the infamous throttle control motor problem.
Old 08-13-13, 09:15 AM
  #6  
Echo419
Rookie
Thread Starter
iTrader: (1)
 
Echo419's Avatar
 
Join Date: Sep 2012
Location: Ga
Posts: 69
Likes: 0
Received 0 Likes on 0 Posts
Default

the car just started up no problems and no CEL.
Originally Posted by GS4_Fiend
Sounds like the infamous throttle control motor problem.
how would I test that?
Old 08-13-13, 10:30 AM
  #7  
1sWt2GS
Lexus Test Driver
iTrader: (6)
 
1sWt2GS's Avatar
 
Join Date: Dec 2010
Location: soCAL
Posts: 6,509
Likes: 0
Received 26 Likes on 17 Posts
Default

i doubt a o2 sensor would cause the car to die like that.
Old 08-14-13, 08:20 AM
  #8  
mk2tmr2
Lead Lap
iTrader: (1)
 
mk2tmr2's Avatar
 
Join Date: Jan 2009
Location: TX
Posts: 512
Likes: 0
Received 1 Like on 1 Post
Default

Definitely not an O2 sensor. The car will run fine with a bad O2 sensor. This sounds like a throttle, MAF or ignition (coil pack) issue. First step is to scan for codes and go from there.
Old 08-15-13, 03:59 AM
  #9  
Echo419
Rookie
Thread Starter
iTrader: (1)
 
Echo419's Avatar
 
Join Date: Sep 2012
Location: Ga
Posts: 69
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by mk2tmr2
Definitely not an O2 sensor. The car will run fine with a bad O2 sensor. This sounds like a throttle, MAF or ignition (coil pack) issue. First step is to scan for codes and go from there.
somebody told me that their MAF went bad after cleaning their intake maybe because the filter wasn't dry enough and some oil got on the sensor ruining it. possibility?

also no codes and "currently" the car runs fine.
Old 08-16-13, 12:10 PM
  #10  
GS4VIPbOSS
Pole Position
iTrader: (9)
 
GS4VIPbOSS's Avatar
 
Join Date: Oct 2007
Location: ca
Posts: 341
Likes: 0
Received 1 Like on 1 Post
Default

Try resetting ECU cant hurt
Old 08-16-13, 12:28 PM
  #11  
Echo419
Rookie
Thread Starter
iTrader: (1)
 
Echo419's Avatar
 
Join Date: Sep 2012
Location: Ga
Posts: 69
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by GS4VIPbOSS
Try resetting ECU cant hurt
I disconnected the battery for a bit then plugged it back up when it first died and it wouldn't start. that didn't change anything.
Old 08-18-13, 09:57 AM
  #12  
Echo419
Rookie
Thread Starter
iTrader: (1)
 
Echo419's Avatar
 
Join Date: Sep 2012
Location: Ga
Posts: 69
Likes: 0
Received 0 Likes on 0 Posts
Default

Cleaned the maf. Runs fine. Let's see if it status that way
Old 08-19-13, 02:36 PM
  #13  
Echo419
Rookie
Thread Starter
iTrader: (1)
 
Echo419's Avatar
 
Join Date: Sep 2012
Location: Ga
Posts: 69
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by GS4_Fiend
Sounds like the infamous throttle control motor problem.
The th throttle body and motor are almost brand new. Guy before replaced it so it has less than 10k on it
Old 09-03-13, 05:37 PM
  #14  
Echo419
Rookie
Thread Starter
iTrader: (1)
 
Echo419's Avatar
 
Join Date: Sep 2012
Location: Ga
Posts: 69
Likes: 0
Received 0 Likes on 0 Posts
Default

so I put the stock aorbit on and finally got a code. P0172 &P0175. from what I've read it seems that it's the O2 sensors. which do I need? rockauto has them for the front and back. I'll post a link in the am if necessary.

ok, so the DIY is for a GS300. I assume that the other O2 is under the drivers side carpet. is this correct?
https://www.clublexus.com/forums/per...placement.html

also here are the O2's I've found. the 2 under the car would be the downtream left/right.
http://www.rockauto.com/catalog/raframecatalog.php?ck[ID]=0&ck[idlist]=0&ck[viewcurrency]=USD&ck[PHP_SESSION_ID]=33leuidi7v7ip9qftv0c0cqil5

Last edited by Echo419; 09-04-13 at 03:49 AM.
Old 09-04-13, 11:15 PM
  #15  
Bhubb18
Pole Position
 
Bhubb18's Avatar
 
Join Date: May 2013
Location: Queensland
Posts: 243
Received 4 Likes on 4 Posts
Default

O2 sensor error is usually a symptom, not the cause


Quick Reply: odd problem



All times are GMT -7. The time now is 06:22 PM.