SorrGwa

iTrader: (1)

FRONT FENDERS

Just curious what some of you did with ur fender liner.

mine front fenders are rolled, but still retain a little bit of a fender lip for the fender liner to attach to (though with zap straps). did u remove the liner completely? without it being attached to the fender lip, it kinda sags and thus rubs on the tire.

those that have the fenders cut, what did u do to the fender liner?

I dont want to completely remove the fender liner, it is vancouver afterall and i dont want rain splatter everywhere...

Thanx.

Mr Jokster

iTrader: (8)

Well, I personally removed mine. However, few ideas are to tuck the liner in that roll real good and the other is to use small 3/8-1/2" screws and screw it upward into the fender (thats what I did before I decided to remove them

Spyder78

iTrader: (7)

Ripped mine out on the highway a long time ago when I was running the 19s. But usually people reform it with a heat gun and than screw them in.

[ant]

the dude who rolled my fenders cut it so it has a peice at the front and back but nothing above the wheel. just looks neater when looking in from front and back. Still lets **** up into the engine bay though! cause this isnt a performance car i rarely open the bonnet and when i do i'm like god damn! theres like an inch of dust and road grime all over the place haha

sakataj

iTrader: (182)

still have them? i need a right front one

haha 2 days after buying mine i ran over a squirrel on the interstate and it ripped mine off....hell in Atlanta last month my under carriage tray ripped off on the interstate (guess i need that too)

SorrGwa

iTrader: (1)

im considering trimming my front fenders this time, then at least with the fender off the car (which i plan on removing off the car to do the hand trimming) i can get a better look at how the fender liner is, and maybe tuck trim, and do some surgery on it.

i really want to push my fronts out a bit more, 20x8.5 +20 is what i want, but with my height, every little bump makes the tire rub the fender liner.

phillygs3

iTrader: (5)

What you need is a smaller tire , I ran a 19x9 + 6 in the front with just a roll .
whta size tire are you running?

SoCal Cyco

iTrader: (20)

i rolled mine wiht a bat, so it is a slight/minor roll, but i run a 255/35/20 with tanabe df210's and have had no issues. the fenderliner is kinda pinched in the roll but it is also still attached at the sides

Kharizma

iTrader: (6)

i took mine out

SorrGwa

iTrader: (1)

fronts are 20x8.5 +35 w a 5mm spacer (to clear calipers), tires are 245/30/20

i want to run a 15mm spacer to push them out to look more flush.

ive had my fronts already rolled a bit, not flat though. ive removed the fender edge trim already. but when i put the 15mm spacers on, they rubbed, thus looking at what i can do to the fender and fender liner to make it work.


the rears are completely fine, its just the fronts that i want to work on.

phillygs3

iTrader: (5)

try a 225/35 tire and you should be fine