Replace intake gaskets when changing starter?
#1
Driver
Thread Starter
Join Date: Oct 2005
Location: AZ
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
Replace intake gaskets when changing starter?
Just curious if it's necessary to change the intake gaskets when replacing the starter, GS400. Price is around $50 for new gaskets.
#3
Driver
Thread Starter
Join Date: Oct 2005
Location: AZ
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
#6
Driver
Thread Starter
Join Date: Oct 2005
Location: AZ
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
No, I'm rebuilding my starter, and the intake gaskets seem to be in nearly perfect condition. I'm just going to re-use them. Need to stop the bleeding.
Last edited by michael200; 10-15-07 at 08:36 PM.
#7
Driver
Thread Starter
Join Date: Oct 2005
Location: AZ
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
A little more info - You don't have to remove the water cross-over pipe at the back of the cylinder heads, to get the starter out. It was fairly easy to remove the starter bolts from the top of the engine, easier than the LS. I bought the parts to rebuild my starter from Sewell, for $57.00 delivered, including new armature bearings, and the solenoid contacts and plunger. The rest of the starter looks nearly new, with 101K miles.
Trending Topics
#8
3UZ-FEEEE
iTrader: (2)
I replaced mine when I changed out the starter... you prolly could get away with it, but I didn't want to risk it personally, or have to do it again, so I bought all the gaskets i MAY even need, including the ones between the upper, and lower part of the intake, never used them though.
You are correct, the LS was tough, and I couldnt do it without removing the cross over pipe.
here is the pic from my 98LS400.
You are correct, the LS was tough, and I couldnt do it without removing the cross over pipe.
here is the pic from my 98LS400.
#9
Driver
Thread Starter
Join Date: Oct 2005
Location: AZ
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
Thanks GRAND_LS4 - I finished rebuilding my starter with new solenoid plunger and contacts and new bearings. Everything went fairly easy. I re-used my intake gaskets, no problem. Total cost was about $75 with new injector o-rings and the rebuild parts.
Thread
Thread Starter
Forum
Replies
Last Post
williamb82
LS - 1st and 2nd Gen (1990-2000)
42
01-17-11 06:50 AM
RomanTPA
LS - 3rd Gen (2001-2006)
5
11-18-10 03:46 PM