DIY: Cuban Wire Harness Relocation! ('93 GS300)
05-13-12, 10:58 PM
#17
what about the passenger side? where do you unplug it on that side? I dont see any plugs until you get into the fender/door panel. Have to cut & extend that side?
Last edited by mkiiisupra; 05-16-12 at 11:04 PM.
08-25-12, 10:17 PM
#18
Driver School Candidate
DIY gs300 Harness relocate
mine was too slammed my wires got cut open and blew a few fuses.. i raised it up after i fixed it and imma try this tomorrow.. what im curious about is u said u didnt have to extend any wires at all? did you plug those sensors back in after you relocated the harness.. sorry im new to the site site but i need slam my car some more any help please!
08-26-12, 06:18 PM
#19
Driver School Candidate
iTrader: (1)
Join Date: Sep 2010
Location: California
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
The passenger side can be unplugged as well but you have to pull back the carpet and unplug the harness near the ecu. It's a bit of a pain but its better than cutting and splicing. You need to unplug two harnesses. One is near the ECU and the other is on the right side of the firewall. It's in that group of plugs with and orange plug in the group.
Thread
Thread Starter
Forum
Replies
Last Post
exxonham
GS - 2nd Gen (1998-2005)
13
03-26-19 11:18 PM
International Mapecu3 with harness
PAVGR
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
9
03-08-16 10:30 AM
