I Need Help!!!!!!!!!! Trying to install my fan clutch . Thought it would be pretty simple but boy was i wrong.(Mechanic Exp. Limited.) A couple of months ago I got my water pump changed out becuz it was leaking . It was replaced with a almost new water pump off a GS300(not sure what year but 2jz) that was getting swapped to GTE. I bought the car with no fan clutch and 2 not working electric fans.
I bought a 2jz fan clutch of rockauto. Yesterday I removed the the E fans and started to install fan clutch. Should be simple theres 4 10mm bolts on the water pump in the car . Removed and tried to slide fan clutch on but the screws donít line up. Screws on water pump are too close to each other, the fan clutch has wider screw setup.(Fan Clutch fit rights on to old water pump. Wider screw setup, also 12mm bolts )
I was told to remove pulley from old water pump and put it on to the new one. So I removed the belt off the pulley and removed pulley from car. Only to find out that the center hole and screw holes are not the same on the pulleys. Water Pump in the car has smaller base than the old water pump.
How can I remove just the end of the water pump that holds the pulley to replace with my old one??? Brown part on water pump is what I need on my water pump.
I know its long but trying to give a clear picture of whats going on. THANKS IN ADVANCE.
This ad is not displayed to registered members. Register your free account today and become a member on Club Lexus!