GS - 4th Gen (2013-2020) Discussion about the 2013 and up GS models

Traction Control Light blinking when changing from Reverse to Drive

Thread Tools
 
Search this Thread
 
Old 03-25-17, 12:09 AM
  #1  
Azeri89
Driver School Candidate
Thread Starter
 
Azeri89's Avatar
 
Join Date: Mar 2017
Location: TX
Posts: 6
Received 0 Likes on 0 Posts
Default Traction Control Light blinking when changing from Reverse to Drive

Hey Guys. The Traction Control of my 14 GS 350 F-Sport is acting weird. When I put the car in drive to go forward, it goes fine. However, if I put it in reverse (to get the car out of my garage) and then switch to drive to go forward, traction control light starts blinking. Even if I leave my foot off the brake, as long as the light is blinking, the car won't move. There are two ways I can stop the light blinking: either put the car to neutral or park and then put it back to drive, or leave the brake pedal then press it again. After doing any of these tricks, traction control light stops blinking and only then I can start driving. The car has been in an accident from the front right side. There is no DTC stored. Any idea what could cause this?
Old 03-25-17, 08:25 AM
  #2  
bclexus
Lexus Test Driver
 
bclexus's Avatar
 
Join Date: Nov 2014
Location: Dallas, Texas
Posts: 8,930
Received 1,991 Likes on 1,415 Posts
Default

Sounds like the Traction Control sensors needs to be checked, but also the ABS sensors too. I believe signals from the ABS sensors are linked with the signals from the Traction Control, so a faulty ABS sensor may trigger the Traction Control light and visa-versa. It would be next to impossible for you to determine which sensor was at fault with any certainty. I'd take it in to the dealer and have them analyze it.
Old 03-25-17, 12:10 PM
  #3  
Azeri89
Driver School Candidate
Thread Starter
 
Azeri89's Avatar
 
Join Date: Mar 2017
Location: TX
Posts: 6
Received 0 Likes on 0 Posts
Default

Originally Posted by bclexus
Sounds like the Traction Control sensors needs to be checked, but also the ABS sensors too. I believe signals from the ABS sensors are linked with the signals from the Traction Control, so a faulty ABS sensor may trigger the Traction Control light and visa-versa. It would be next to impossible for you to determine which sensor was at fault with any certainty. I'd take it in to the dealer and have them analyze it.
Thanks bclexus! I am going to receive my OBDII reader with Techstream software. If either ABS or Traction Control Sensors are faulty, would it register any DTC code so that I can read it with Techstream? if not, any idea how would dealer go about checking which sensor is faulty?
Old 03-25-17, 12:50 PM
  #4  
bclexus
Lexus Test Driver
 
bclexus's Avatar
 
Join Date: Nov 2014
Location: Dallas, Texas
Posts: 8,930
Received 1,991 Likes on 1,415 Posts
Default

The way it is reacting I kind of doubt it is throwing a code. I suspect the dealer's technician has a procedure he goes through that may have a special analyzer that includes spare sensors.
The following users liked this post:
Azeri89 (03-25-17)
Old 03-25-17, 06:16 PM
  #5  
Azeri89
Driver School Candidate
Thread Starter
 
Azeri89's Avatar
 
Join Date: Mar 2017
Location: TX
Posts: 6
Received 0 Likes on 0 Posts
Default

Originally Posted by bclexus
The way it is reacting I kind of doubt it is throwing a code. I suspect the dealer's technician has a procedure he goes through that may have a special analyzer that includes spare sensors.
Thanks bclexus! I am going to take it to a dealer as soon as I get a chance and will post the results.
Old 03-25-17, 06:47 PM
  #6  
Azeri89
Driver School Candidate
Thread Starter
 
Azeri89's Avatar
 
Join Date: Mar 2017
Location: TX
Posts: 6
Received 0 Likes on 0 Posts
Default

Problem solved. Actually, it was not a problem to begin with, I was just an idiot. When I back up, I press the brake pretty hard (to bring the car to a complete stop so that I don't put the car to drive while the car is moving backward), and apparently, that turns on the hill assist. Did not know it was a thing since my previous car 06 gs 300 did not have that feature.
Old 03-25-17, 07:14 PM
  #7  
bclexus
Lexus Test Driver
 
bclexus's Avatar
 
Join Date: Nov 2014
Location: Dallas, Texas
Posts: 8,930
Received 1,991 Likes on 1,415 Posts
Default

Damn, you mashed on that brake pedal pretty hard for the Hill Assist to activate...

Glad you do not have a problem.
Old 03-25-17, 07:18 PM
  #8  
kamskeez
Pole Position
 
kamskeez's Avatar
 
Join Date: May 2016
Location: CA
Posts: 316
Received 29 Likes on 26 Posts
Default

How hard to you mash that pedal? Lol I even have a hard time getting that thing to turn on sometimes.
Old 03-25-17, 07:24 PM
  #9  
bclexus
Lexus Test Driver
 
bclexus's Avatar
 
Join Date: Nov 2014
Location: Dallas, Texas
Posts: 8,930
Received 1,991 Likes on 1,415 Posts
Default

Originally Posted by kamskeez
How hard to you mash that pedal? Lol I even have a hard time getting that thing to turn on sometimes.
If you don't have thighs the size of a telephone pole and calves the size of a pig's head you don't have the leg strength to activate the Hill Assist.

Old 03-25-17, 10:35 PM
  #10  
yardie876
Lexus Champion
 
yardie876's Avatar
 
Join Date: Sep 2012
Location: SoFlo
Posts: 3,438
Received 87 Likes on 73 Posts
Default

LOL ease up on the pedal there.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
KJD3
GS - 4th Gen (2013-2020)
7
07-15-22 02:07 PM
Gtzfabb
IS - 2nd Gen (2006-2013)
2
04-25-16 11:52 AM
Jack777
GS - 4th Gen (2013-2020)
4
01-24-15 06:47 PM
Stoyamajello
SC- 1st Gen (1992-2000)
1
05-07-12 11:23 AM
tastfulmod
IS - 2nd Gen (2006-2013)
5
09-18-11 10:00 PM



Quick Reply: Traction Control Light blinking when changing from Reverse to Drive



All times are GMT -7. The time now is 04:46 AM.