mikespo23

I vinyl wraped my front bumper as seen in pic below and it is effects my front parking sensors. I was told from a few people that I should cut out the circle outlines of the sensors and color them in with a black magic marker, I'm a little skeptical... Does anyone have any suggestions or should I just forget about those sensors and just leave it be?

GsLex02

Damn dude that sucks. But guess what.....your car looks dope lol I'd say "F" it keep it how it is and do without the front sensors.

yardie876

I've seen people vinyl the front sensors with no issue. It must have to do with the thickness of the vinyl...

Don Nguyen

Usually it is fine. When people put clear bra on their cars, it typically includes the sensors as well.

veez81

I have Xpel on my front bumper. Parking sensors were covered and work fine.

bigblack06

iTrader: (20)

There shouldn't be an issue, I had the 13+ and the only time the sensors would go off randomly was when it was cold, could be same reason but might need to try turning it off and on I know I did and it never occurred again.

mcomer

Our 3M installer cuts out the sensor circles.

You can change the front sensor sensitivity in Setup/vehicle.

The random "cold" alert is most likely from snow/ice covering the sensors.

mrkwinning

It may not be the vinyl wrap... Looks like your license plate mount could interfered. I would take it off and check if you still have issues.

Sevn86

My plate is located in the same area as the OP and I haven't had any issues at all.

tc1728

I have cars wrapped with 3M and with Avery films and no issues at all