0mghi2u

iTrader: (3)

Well I haven't had any issues with brake dust. But then again I own a car wash lol so I wash it almost everyday. But when I didn't wash it for a week it was still pretty clean

Sosodef79

iTrader: (1)

Got any new pics sniper?

0mghi2u

iTrader: (3)

Here are side pics with skipper lip. Can't get the front bumper cf garnish to stay on with double sided tape so gotta figure that out.

0mghi2u

iTrader: (3)

More pics.

obturator

lookin' good. Are u opposed to attaching lip with screws?

SNiiP3R

iTrader: (3)

What's inside that box on the rear seat?

Have you tried applying heat to the tape before putting it on the bumper?

0mghi2u

iTrader: (3)

No I attached with screws and 3m double sided tape.

0mghi2u

iTrader: (3)

Haha that's the bumper garnish.

I put the double sided tape on the cf piece and set it in the sun and after the first attempt. Sitting in sun for a few hours it started to sag. Problem I think is the cf piece on the back is just the rough fiberglass fiber not smooth. I don't want to epoxy it cuz then it's permanent.

0mghi2u

iTrader: (3)

Side view.

3m clear bra on cf lip looks like crap. Oh well better then chips. Lol

obturator

All good if that's a diy.....if u paid someone, then that's another story...lol

0mghi2u

iTrader: (3)

Lol yea I did it myself :/

DoriSaru15

Did you use all 7 screw points and the self taping screw that came with it? Its suppose to stay on without double sided tape.

0mghi2u

iTrader: (3)

[QUOTE=DoriSaru15;8684691]Did you use all 7 screw points and the self taping screw that came with it? Its suppose to stay on without double sided tape.[/QUOTE

Yea I used all 7 screws. And I just used double sided tape just for my piece of mind. Lol