Vled V3 Triton in front turn signal lamp

Reply Subscribe

Thread Tools

Search this Thread

08-12-16, 07:05 PM

#16

Hendo808

Driver School Candidate

Join Date: Aug 2016

Location: Colorado

Posts: 8

Likes: 0

Received 0 Likes on 0 Posts

Quote:

Originally Posted by rl9010

Insert and twist....I am not following your question. There is just enough clearance in the front headlamp.

ill try again tomorrow I guess. I fiddled with mine for a while before I gave up because it didn't look like there was enough clearance. Did you do your rear ones too?

Reply Like

08-14-16, 10:06 PM

#17

rl9010

Lead Lap

Thread Starter

Join Date: Sep 2007

Location: CA

Posts: 518

Likes: 18

Received 51 Likes on 40 Posts

Quote:

Originally Posted by Hendo808

ill try again tomorrow I guess. I fiddled with mine for a while before I gave up because it didn't look like there was enough clearance. Did you do your rear ones too?

I believe I have everything retracted as much as possible to create the most clearance. I know the heat sink is almost touching the plastic housing. Maybe maneuver the relay and wires in the lamp a bit.

I went with carmate led direct replacement for the rear. There is not enough clearance for the v3's in the rear.