GS 350 Performance questions
#17
http://l-tunedparts.com/index.php
Any know if it would make sense to throw on an F sport exhaust with this set up? Or if most of the f sport stuff can be swapped over into this vehicle? It pretty much looks like turbo isnt a real option here either. I'm kinda disappointed now. Looks like I picked the wrong platform to start with! I'm going to have to consider what to do with it now....
http://lexus.sewellparts.com/accesso...S350-2008.html
#18
Driver School Candidate
iTrader: (1)
[QUOTE=YaMomma;8487714]Be careful buying intakes for an 06GS300, that's what I have and the GS300 and GS350 intakes are different. Since the 2006 engine was only made for a year there aren't a lot of options. There use to be a few out there but DC is the only company that still makes a cold air intake for an 06. At this point K&N's cold air intake is rare because they stopped making it for the 06 a long time ago. Fujita is rare but I doubt you will find one. Even if you do be careful because the early models caused error codes. Scratch joez off your list because that will not fit a 300. The following site may have some rare parts but I think everything on there site is overpriced.
http://l-tunedparts.com/index.php
good to know! do you know if the 2GIS f sport intake will fit on the 3GS300?
http://l-tunedparts.com/index.php
good to know! do you know if the 2GIS f sport intake will fit on the 3GS300?
#19
I don't know for sure either way but i doubt it. There aren't any F-Sport intake products that work for an 06 to my knowledge. I ordered the F-Sport air filter from my Lexus dealer but it didn't fit my 06. It came up as the right part because I guess there are some 06 350's out there.
#21
Lead Lap
iTrader: (2)
I don't know too much about the 3gs but I do know enough to get me around. just make sure when you order parts that it will fit. I haven't seen much parts for the 06 3gs and never could figure out way
just IMO, if I can't fully fabricate the part I want, ill buy a similar part with close measurements and just mod it to where it will work and fit properly.
thanks but I took it from another thread here on the forum.
just IMO, if I can't fully fabricate the part I want, ill buy a similar part with close measurements and just mod it to where it will work and fit properly.
thanks but I took it from another thread here on the forum.
Thread
Thread Starter
Forum
Replies
Last Post