Inside door handle not working
#1
Driver School Candidate
Thread Starter
Inside door handle not working
I have an 07 GS 350 and the inside passenger front door handle stopped working. It will still open from the outside, but not inside. Has anyone else had this problem, and is there a simple fix for it?
#3
Driver School Candidate
Thread Starter
#4
Driver School Candidate
Thread Starter
#6
in your door handle, tape a small flathead, and pry open the cap under the flathead, there is one screw there, now in the middle of your door is a led light (CENTER of the door panel) pop it open with the flathead again, there's another screw there. It's preferential how to pull the door panel, I just pull and slide up.....
I think you either broke the plastic to the door handly holding the cable (which is really hard to break) or it just broke loose.
GL OP!
I think you either broke the plastic to the door handly holding the cable (which is really hard to break) or it just broke loose.
GL OP!
#7
in your door handle, tape a small flathead, and pry open the cap under the flathead, there is one screw there, now in the middle of your door is a led light (CENTER of the door panel) pop it open with the flathead again, there's another screw there. It's preferential how to pull the door panel, I just pull and slide up.....
I think you either broke the plastic to the door handly holding the cable (which is really hard to break) or it just broke loose.
GL OP!
I think you either broke the plastic to the door handly holding the cable (which is really hard to break) or it just broke loose.
GL OP!
Trending Topics
#8
Driver School Candidate
Thread Starter
Took the door panel off and couldn't find anything. Put it back together and it worked about 3 times and quit. Did this about 5 times and keep getting the same thing. Can't figure this out to save my life!
#9
Could you take very detailed pictures of the door handles before disconnecting the two cables (lock and door opener cable)? Then disconnect the cables, take detailed pictures of the slots. You said they worked 3 times and quit...... i'm assuming your placeholder is broken for the cables or the ports on the OTHER end of the cables broke.
Thread
Thread Starter
Forum
Replies
Last Post
mr nut
SC- 1st Gen (1992-2000)
12
09-25-07 05:37 PM