DIY - Ebay's 98-01 Land Cruiser Dual Fog Light Mod
08-30-18, 11:35 AM
#155
Pole Position
Did anyone else find these?
Looking for a set for my 400
Looking for a set for my 400
08-30-18, 11:49 AM
#156
Driver School Candidate
Join Date: Aug 2018
Location: Nevade
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Would you sell these?
After posting up a picture of my car. I was asked by many if I could do a write up on how I fitted the fog light into the bumper.
This process is not reversible once you cut or heat up your stock bumper. I am not accountable if you mess up following these steps.
Assuming you know how to take off the front bumper & wiring up fog light. If not then there is plenty of direction on the forum and Google. So I will skip these steps.
Item used in this project.
- Heat gun,
- Sharp razor blade
- Metal or wood stick/bar (need it to shape the bumper while its hot.)
- 10 screws and washer. (5 screw and washer for each side)
- Power drill unless you want a workout use a hand screw driver.
- A set of 98-01 Land Cruiser fog light off EBay. ($75)
1. Once the OEM light is out. Place the LC fog light in & measure how much to cut the fins. Its best to keep it a little longer. You can always trim for a nice fit but it’s hard to make a short fin longer. Keep measuring & trim little by little till you get the fin to fit nicely with the fog light.
This process is not reversible once you cut or heat up your stock bumper. I am not accountable if you mess up following these steps.
Assuming you know how to take off the front bumper & wiring up fog light. If not then there is plenty of direction on the forum and Google. So I will skip these steps.
Item used in this project.
- Heat gun,
- Sharp razor blade
- Metal or wood stick/bar (need it to shape the bumper while its hot.)
- 10 screws and washer. (5 screw and washer for each side)
- Power drill unless you want a workout use a hand screw driver.
- A set of 98-01 Land Cruiser fog light off EBay. ($75)
1. Once the OEM light is out. Place the LC fog light in & measure how much to cut the fins. Its best to keep it a little longer. You can always trim for a nice fit but it’s hard to make a short fin longer. Keep measuring & trim little by little till you get the fin to fit nicely with the fog light.
08-01-19, 06:07 PM
#157
Pole Position
My GS4 is totalled but I'm looking for a set of these to retrofit for a new potential "project" ;-)
Has anyone located them lately?
if so, where?
Has anyone located them lately?
if so, where?
01-04-20, 03:06 PM
#158
Driver School Candidate
i know thread is old but your welcome
https://www.ebay.com/itm/Fit-For-Lex...97.m4902.l9144
https://www.ebay.com/itm/For-Jzs160-...97.m4902.l9144
https://www.ebay.com/itm/Fit-For-Lex...97.m4902.l9144
https://www.ebay.com/itm/Fit-For-Lex...97.m4902.l9144
https://www.ebay.com/itm/For-Jzs160-...97.m4902.l9144
https://www.ebay.com/itm/Fit-For-Lex...97.m4902.l9144
The following users liked this post:
tiguy99 (02-03-20)
Thread
Thread Starter
Forum
Replies
Last Post
