GS - 2nd Gen (1998-2005) Discussion about the second generation GS300, GS400 and GS430 (1998 - 2005)

1999 GS300 rattling

Thread Tools
 
Search this Thread
 
Old 01-07-13, 05:47 PM
  #1  
mexguy89
Rookie
Thread Starter
iTrader: (3)
 
mexguy89's Avatar
 
Join Date: Jan 2013
Location: Ca
Posts: 68
Likes: 0
Received 1 Like on 1 Post
Default 1999 GS300 rattling

Wass up everyone I'm new to the lexus world & new to forum.
I just purchase a 1999 Gs300 with 117,000 miles this past friday loving it so far great smooth car, Yesterday I stop at lights, stops notice that it rattles a little from the front lest it's worrying me. It doesn't happen when its running only when stop and the brake is pressed, anyone has an idea what can be sounds like something is lose?
NOTE: Previous owner put new timming belt & water
Old 01-07-13, 05:51 PM
  #2  
SC400slide
In Recovery Mode

iTrader: (11)
 
SC400slide's Avatar
 
Join Date: Apr 2012
Location: NM
Posts: 3,868
Received 33 Likes on 27 Posts
Default

Is it a metal on metal rattle? Or an engine rattle?
Old 01-07-13, 06:25 PM
  #3  
mexguy89
Rookie
Thread Starter
iTrader: (3)
 
mexguy89's Avatar
 
Join Date: Jan 2013
Location: Ca
Posts: 68
Likes: 0
Received 1 Like on 1 Post
Default

Metal sound from front left
Old 01-07-13, 07:10 PM
  #4  
Guitarman
Moderator
 
Guitarman's Avatar
 
Join Date: Jan 2002
Location: Florida
Posts: 1,835
Likes: 0
Received 3 Likes on 3 Posts
Default

Last year I had something very similar, it was coming from the driver's side front wheel area. I thought I had a bad tie rod or blown shock, the rattle was really bad over any road bumps or irregularities/ rough pavement. Took it to my local shop and they found one of the caliper pins worn badly. The repair was less than $50 and the car felt and sounded new again.

It was my car's 3d repair in 15 years, so I'm not complaining at all...Worth a shot to take a look.
Old 01-07-13, 07:19 PM
  #5  
sam12345
Lexus Champion
iTrader: (1)
 
sam12345's Avatar
 
Join Date: Nov 2009
Location: tx
Posts: 2,044
Likes: 0
Received 9 Likes on 9 Posts
Default

Just make sure you check the ball joint (see the sticky)
Old 01-07-13, 07:42 PM
  #6  
nyc80rick
Lead Lap
 
nyc80rick's Avatar
 
Join Date: May 2012
Location: VA
Posts: 657
Received 12 Likes on 11 Posts
Default

check the exhaust clamps/straps because of age mine was not holding the exhaust tight anymore and was rattling when I was stopped. sounds like it might be it

Last edited by nyc80rick; 01-07-13 at 07:50 PM.
Old 01-07-13, 09:58 PM
  #7  
mexguy89
Rookie
Thread Starter
iTrader: (3)
 
mexguy89's Avatar
 
Join Date: Jan 2013
Location: Ca
Posts: 68
Likes: 0
Received 1 Like on 1 Post
Default

Thanks everyone tomorrow I'm having a tune up done to it ill have my mechanic check ill keep in touch
Old 01-08-13, 06:18 PM
  #8  
Acer
Lead Lap
iTrader: (3)
 
Acer's Avatar
 
Join Date: Sep 2011
Location: fl
Posts: 433
Likes: 0
Received 0 Likes on 0 Posts
Default

update?...
Old 01-09-13, 01:56 AM
  #9  
kyliemac91
Driver School Candidate
 
kyliemac91's Avatar
 
Join Date: Dec 2012
Location: OC, CALI
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
Default

the same thing happened to me, but the mechanic told me to change my drive belt
Old 01-09-13, 03:29 PM
  #10  
tinman
Intermediate
 
tinman's Avatar
 
Join Date: Nov 2003
Location: Oswego, IL
Posts: 266
Received 1 Like on 1 Post
Default

Mine did the same thing, turned out to be the exhaust shield over the catalytic converter. Clamped it down, fixed!
Old 01-20-13, 01:07 AM
  #11  
mexguy89
Rookie
Thread Starter
iTrader: (3)
 
mexguy89's Avatar
 
Join Date: Jan 2013
Location: Ca
Posts: 68
Likes: 0
Received 1 Like on 1 Post
Default

no update yet rattle sound still there been working for most part all daytime by the time I get home very dark. Will check all exhaust clamps also hear shields. question where is the heat shields towards front left?
Old 01-20-13, 11:18 AM
  #12  
mexguy89
Rookie
Thread Starter
iTrader: (3)
 
mexguy89's Avatar
 
Join Date: Jan 2013
Location: Ca
Posts: 68
Likes: 0
Received 1 Like on 1 Post
Default

UPDATE: I lift my gs300 this morning exhaust seem very clamp everything look good. So I turn to my heat shield behind the rotor it was intact but it was lean against the rotor causing vibration when the car was in drive and breake applied. It was an easy fix all I did was pull it back making space and bamm solved. drove it around the block a couple times stop very often and no vibration.
Old 07-01-14, 01:21 PM
  #13  
SaiyanGS3
Racer
iTrader: (8)
 
SaiyanGS3's Avatar
 
Join Date: May 2011
Location: H-town, TX
Posts: 1,639
Received 86 Likes on 70 Posts
Default

Originally Posted by tinman
Mine did the same thing, turned out to be the exhaust shield over the catalytic converter. Clamped it down, fixed!
Wanted to bump this old thread. This is starting to happen to my car now, especially once I turn on the AC. This is pissing me off. I didn't know I had this problem until I had my window down at the drive thru recently. Got to check this out.
Old 07-02-14, 08:11 PM
  #14  
Lukas99GS
Instructor
 
Lukas99GS's Avatar
 
Join Date: Jan 2013
Location: MN
Posts: 886
Likes: 0
Received 32 Likes on 23 Posts
Default

I had a similar noise, turned out the heat shield on the exhaust was rotting away, lexus took it off for no charge
Old 07-03-14, 02:30 PM
  #15  
GSGenesis
Pole Position
 
GSGenesis's Avatar
 
Join Date: Apr 2014
Location: Ca
Posts: 383
Likes: 0
Received 1 Like on 1 Post
Default

Things I can think of it being, and would have first said, Check all heat shields to make sure they aren't loose, cats and all, Check dust shields behind rotors, and also now is it a rattle? Or a pop corn type noise? If it sounds like popcorn kernels popping kind of, servo motors. Very common. A/C Servo motors. In which case there's a DIY for how to take them apart and regrease them, which I confirmed works 100% besides that, um, sure there's tons more but start there...
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Bestlex1
GS - 2nd Gen (1998-2005)
13
11-28-18 08:48 AM
CrimsonGS
Suspension and Brakes
12
05-05-16 03:58 PM
ChanceL
GS - 1st Gen (1993-1997)
5
07-27-07 12:16 PM
Tebabee
GS - 2nd Gen (1998-2005)
9
04-14-04 01:35 PM



Quick Reply: 1999 GS300 rattling



All times are GMT -7. The time now is 04:58 AM.