Check out my custom front lip. Still only a mock up and unfinished.
#1
Driver
Thread Starter
Join Date: May 2004
Location: Illinois
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
Check out my custom front lip. Still only a mock up and unfinished.
Ok guys, before you guys ask why did I do this. Because this lip was free and I had some free time on my hands. I figure why not try something new and see where it goes. This lip is an OEM front lip off an 07 Camry SE, so not only is it urethane it is top quality . I didn't want to fork out 200+ for a TTE lip or any other for that matter. Total cost so far has been 1 hour of my time . Like I said, this is only a mock up and no way near finished. Still need a lot of trimming and cutting to make it sit flush, then off to prep and paint.
As of now, I'm not even 100% sure I want to put this lip on my car, if I finish it and like how it looks then I might. Please give all comments and criticism, good or bad. I don't care if you hate it or love it. Maybe you guys can give suggestion on how else I can change it up. On side note, I love how the stock holes for the fog lights fit perfectly on mine.
As of now, I'm not even 100% sure I want to put this lip on my car, if I finish it and like how it looks then I might. Please give all comments and criticism, good or bad. I don't care if you hate it or love it. Maybe you guys can give suggestion on how else I can change it up. On side note, I love how the stock holes for the fog lights fit perfectly on mine.
#4
Sorry but that lip doesnt look good on a lexus. I know it not finish, but it reminds me of rice rocket with body kits screwed on because they found out that it cost more to mold the body kit on then body kit cost itself.
Trending Topics
#13
Driver
Thread Starter
Join Date: May 2004
Location: Illinois
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
Keep the comments and critizism coming....... Not even sure if there would be a finished state, if I feel I will not dig the looks I'll just stop. I'm planning to keep the lines on the lip, not trying to mold or fiberglass anything. Keeping my cost low as can be and maybe end up with a half decent lip