NoUltimatu

I am trying to remove the front left hub so I can have a shop push out the bearing.
I have gotten it to where just the ABS sensor is on and holding me from pulling out the hub.

I have removed the 10mm bolt from it. It seems to spin freely around the ABS line. How do I remove it?

Second question is: when I go to the shop, will I need just 1 part (bearing) or is it a bunch of parts? Because the diagram shows about 7 parts going in to that. Thanks

NoUltimatu

Nevermind. Figured it out by watching this Toyota video. Apparently I need to keep wiggling and maybe pry it off.

FrankT

Provide them with a new spindle nut...
I believe the old one is staked and will damage the threads if reused.

marshun

the old one is notched, you can reuse it.

have fun. wheel bearings are a pain

FrankT

The nut is a non reusable part costing less than $5.00. Yes folks will reuse them, I have in the past and in turn ruined the threads on the spindle.

My advice is always based on personal experience so take it for what it's worth to you...