***** Offical Rolling Shot Thread *****
#101
What setting on the camera do you want to adjust to make it look like the wheels are in a motion blur?
Right now it seems like all the rolling shot pics I take when the car is in motion it doesn't look like the car is moving... any info would help - thanks!
Anyways I was going through my pictures archive and found an older rolling shot of my 1st set of wheels, 20" Niche F-18...
Here's the video of the above wheel....
http://www.youtube.com/watch?v=yHdadREXE8Y (this was before drop or any other mods)
Right now it seems like all the rolling shot pics I take when the car is in motion it doesn't look like the car is moving... any info would help - thanks!
Anyways I was going through my pictures archive and found an older rolling shot of my 1st set of wheels, 20" Niche F-18...
Here's the video of the above wheel....
http://www.youtube.com/watch?v=yHdadREXE8Y (this was before drop or any other mods)
Last edited by SHiZNiLTi; 08-18-09 at 01:00 PM.
#105
Lexus Test Driver
Join Date: May 2008
Location: australia
Posts: 878
Likes: 0
Received 0 Likes
on
0 Posts
^ i reckon he'd roll fine if he has shaved the fenders or rolled them pretty flat. mine are rolled like 1/2 size front and rear and i scrub a little but not much. if i had the cash to roll all round and repaint fenders (or just shave flat or close to) i would get 10mm spacers rear and 15mm front at least and probably still roll okay!
here's a couple of mine from the other weekend...
i know, the aerial is lame, it comes on Aussie delivered GS. i dont have the cash to get the thing removed, welded and repainted so i may look into just disconnecting it and hooking up a window one or something :/ least i wont look like an R/C car lol
2ndly, i know, it isnt low enough, esp not at the front. that's maxed out on Insurance Group coilovers :/ so probably go S/S kit next get a bit lower and bit flusher by removing some camber...
here's a couple of mine from the other weekend...
i know, the aerial is lame, it comes on Aussie delivered GS. i dont have the cash to get the thing removed, welded and repainted so i may look into just disconnecting it and hooking up a window one or something :/ least i wont look like an R/C car lol
2ndly, i know, it isnt low enough, esp not at the front. that's maxed out on Insurance Group coilovers :/ so probably go S/S kit next get a bit lower and bit flusher by removing some camber...