ES - 1st to 4th Gen (1990-2006) Forum for all 1990 - 2006 ES300 and ES330 models. ES250 topics go here as well.

What have you done to your ES today?

Old 04-14-14, 06:03 AM
  #451  
brucelee1
Racer
iTrader: (2)
 
brucelee1's Avatar
 
Join Date: Sep 2007
Location: MA
Posts: 1,335
Received 87 Likes on 74 Posts
Default

Rubber mats, out, carpeted mats, in. Vacuumed the interior.
Old 04-14-14, 08:44 AM
  #452  
clintbw
Rookie
 
clintbw's Avatar
 
Join Date: Mar 2014
Location: CO
Posts: 52
Likes: 0
Received 0 Likes on 0 Posts
Default

Well I finally had the chance to shampoo the carpet in my car. It was unbelievably nasty.. looked like there were spilled Coca Cola/Dr Pepper in the back and plenty of dirt embedded in the floor. I bought new Lexus mats and covered it up until I had access to the Bissell Big Green Machine from Lowes (we rent it every few months for the carpet in the house as we have dogs)...

I spent about two hours total, including pre-treating the carpet. I went over it a few times with the cleaner. The waste water was absolutely filthy. The car smells so much better and the carpet looks plush and clean now! I recommend this machine. You can rent it from Lowes for about $25 a day.

Before:

Last edited by clintbw; 04-14-14 at 09:10 AM.
Old 04-14-14, 08:51 AM
  #453  
clintbw
Rookie
 
clintbw's Avatar
 
Join Date: Mar 2014
Location: CO
Posts: 52
Likes: 0
Received 0 Likes on 0 Posts
Default

And after:



No more strange smells either. I also used ScotchGuard after it was cleaned to protect from further stains.

Last edited by clintbw; 04-14-14 at 08:55 AM.
Old 04-14-14, 11:16 AM
  #454  
PuReChaos
Pole Position
 
PuReChaos's Avatar
 
Join Date: Sep 2012
Location: WA
Posts: 386
Likes: 0
Received 4 Likes on 4 Posts
Default

@Clintbw its hard to tell the difference it made other than the space directly behind the center storage compartment as its covered by the new mats. Looks good though.
Old 04-18-14, 10:04 AM
  #455  
philiprace
Driver School Candidate
 
philiprace's Avatar
 
Join Date: May 2013
Location: IL
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default

I installed a cold air intake and put on a strut bar.
Old 04-23-14, 09:17 PM
  #456  
lexusdod
Driver School Candidate
 
lexusdod's Avatar
 
Join Date: May 2010
Location: tx
Posts: 15
Likes: 0
Received 0 Likes on 0 Posts
Default

Should be "what have i done to my lexus all week"! It started blowing out oil at the rate of 1 qt per 50 miles and i couldnt find the leak(somewhere on front of motor). So i started taking stuff off looking(timing cover, fender wall behind tires) Found several things. CV joint boot riped, oil leaking from cam and crank seals and possibly from oil pan, valve cover and oil pump, all motor mounts shreaded, crank pulley damaged and wearing hole in timing cover, spark plugs wore out. So I pulled the motor to work on everything. Been going since the 19th and most of the stuff done, just waiting of 2 parts i broke(transmission plug and timing pully on crankshaft). Should have it back running by the end of the month. Will spend about 1000.00 on parts. Glad iam not charging myself labor! 244,000 miles without much service done, so it needs a little work.
Old 04-25-14, 04:53 AM
  #457  
speedkar9
Lexus Champion
 
speedkar9's Avatar
 
Join Date: Aug 2012
Location: Toronto, Canada
Posts: 1,729
Likes: 0
Received 118 Likes on 89 Posts
Default

Balanced wheels and got a new flex pipe. Car is quiet and smooth now .

Originally Posted by philiprace
I installed a cold air intake and put on a strut bar.
Got any pics?
Old 04-26-14, 02:13 PM
  #458  
brucelee1
Racer
iTrader: (2)
 
brucelee1's Avatar
 
Join Date: Sep 2007
Location: MA
Posts: 1,335
Received 87 Likes on 74 Posts
Default

Oil change, Filter and drain and fill on the trans.

BTW-the Quaker State Full syn oil is the bomb.
Old 04-26-14, 05:22 PM
  #459  
imherenow
Racer
 
imherenow's Avatar
 
Join Date: Aug 2005
Location: TX, CA
Posts: 1,754
Received 9 Likes on 9 Posts
Default

so did a few cosmetics changes and washed the car too:
1) its been a long time since i had the OEM DRL on. so i thought to give it a try and took pics too to see how it looks with the non-oem drl (fogs). Well it sucks. so i put the fogs as drl back on
2) i bought some fancy "pillows" and put them at back near the rear speakers . i think it looks good
3) gave a good clean of the carpets for the trunk
4) i also removed the spare tire. and instead purchased a inflatable seal can and air pump. Meh no need for that rear tire. i think the car should be gliding with that weight gone :P

Anyways here are some shots:
Attached Thumbnails What have you done to your ES today?-dscf0627.jpg   What have you done to your ES today?-dscf0644.jpg   What have you done to your ES today?-dscf0662.jpg   What have you done to your ES today?-dscf0647.jpg   What have you done to your ES today?-dscf0663.jpg  

Old 04-26-14, 07:40 PM
  #460  
speedkar9
Lexus Champion
 
speedkar9's Avatar
 
Join Date: Aug 2012
Location: Toronto, Canada
Posts: 1,729
Likes: 0
Received 118 Likes on 89 Posts
Default

Originally Posted by imherenow
so did a few cosmetics changes and washed the car too:
Anyways here are some shots:
Why is your foot-well light yellow and not LED? What happened to your door logo lights?

You should work on a door sill mod next....
Old 04-27-14, 06:20 AM
  #461  
brucelee1
Racer
iTrader: (2)
 
brucelee1's Avatar
 
Join Date: Sep 2007
Location: MA
Posts: 1,335
Received 87 Likes on 74 Posts
Default

Nice looking 97. How did you get that logo on the armrest?
Old 04-27-14, 08:21 AM
  #462  
imherenow
Racer
 
imherenow's Avatar
 
Join Date: Aug 2005
Location: TX, CA
Posts: 1,754
Received 9 Likes on 9 Posts
Default

Originally Posted by speedkar9
Why is your foot-well light yellow and not LED? What happened to your door logo lights?

You should work on a door sill mod next....
Ya those foot-well leds were just too bright, so i am looking for a just single led "bulb". I just want that light,welcoming interior since my dome leds are just bright. So for now i have simple halogen bulbs. and they are not yellow . i guess its the cameras fault.
And ya i removed the door logo lights too. Its because they were chinese made ones and got burned from inside. Oh well i will have to look for american made ones.

Originally Posted by brucelee1
Nice looking 97. How did you get that logo on the armrest?
Its not 97, but 2000 year model. That logo on armrest was etched from the factory
Old 04-27-14, 04:43 PM
  #463  
speedkar9
Lexus Champion
 
speedkar9's Avatar
 
Join Date: Aug 2012
Location: Toronto, Canada
Posts: 1,729
Likes: 0
Received 118 Likes on 89 Posts
Default

Originally Posted by imherenow
And ya i removed the door logo lights too. Its because they were chinese made ones and got burned from inside.
Interesting, mine are still holding up after 6 months.
Old 04-27-14, 06:06 PM
  #464  
imherenow
Racer
 
imherenow's Avatar
 
Join Date: Aug 2005
Location: TX, CA
Posts: 1,754
Received 9 Likes on 9 Posts
Default

Originally Posted by speedkar9
Interesting, mine are still holding up after 6 months.
wait were they the same ones that i had linked you long time back?,,plus only one of them went out. oh well
Old 04-28-14, 01:12 AM
  #465  
AntzCro
Driver
 
AntzCro's Avatar
 
Join Date: Feb 2012
Location: Australia
Posts: 133
Likes: 0
Received 1 Like on 1 Post
Default

Changed my oil and oil filter ( 5W30 and Z418 Filter)
Went down to my local Toyota warehouse to find a Cabin air filter to replace them as I believed they had never been replaced ( which i was correct ). 15 years without a replacement.

And before i fitted the new filter

Thread Tools
Search this Thread
Quick Reply: What have you done to your ES today?



All times are GMT -7. The time now is 04:40 PM.