Engine goes to idle RPM after revving to 3000
#1
Driver School Candidate
Thread Starter
Join Date: Jan 2011
Location: NC
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Engine goes to idle RPM after revving to 3000
Hey guys, new to the forum here, hoping to get some help?
Yesterday I changed fitlers...an hour later I turned on the car and it would immediately die after starting.
I took it apart and cleaned everything (throttle, MAF...) with the carbon cleaner....now it'll turn on but when I rev the engine past 3000 it goes immediately back to idle.
I haven't tried to drive it yet but I'm not sure what the problem could be.
Any help would be extremely appreciated.
Yesterday I changed fitlers...an hour later I turned on the car and it would immediately die after starting.
I took it apart and cleaned everything (throttle, MAF...) with the carbon cleaner....now it'll turn on but when I rev the engine past 3000 it goes immediately back to idle.
I haven't tried to drive it yet but I'm not sure what the problem could be.
Any help would be extremely appreciated.
#3
Are you pulling any CEL codes?
Sounds like when you clean the TB, it may have left some gunk around the flap causing the TPS to get a false reading.
Get a helper to press the accelerator pedal all the way down and make certain there is no slack or too tight at the throttle body cable connection. If slack/looseness, adjust until it is within spec.
If this does not fix it your TPS ( Throttle Position Sensor maybe defective ), hope not.
Sounds like when you clean the TB, it may have left some gunk around the flap causing the TPS to get a false reading.
Get a helper to press the accelerator pedal all the way down and make certain there is no slack or too tight at the throttle body cable connection. If slack/looseness, adjust until it is within spec.
If this does not fix it your TPS ( Throttle Position Sensor maybe defective ), hope not.
Thread
Thread Starter
Forum
Replies
Last Post