ES300 Starting problems
#1
Driver School Candidate
Thread Starter
Join Date: Jan 2010
Location: Fl
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
ES300 Starting problems
I have a 1994 ES300 that I recently change the ti-rods on, since then whenever I start the car and put in drive it does not move, I have to wait 10-20 minutes before it engages then I can move. Any suggestions as to what the problem is?
#2
Changing the tie rods has no correlation to the problem you are experiencing other then possibly you knocked something loose. I would look very closely in the areas you were working in.
#3
Lexus Champion
this thread is so misnamed its not even funny.
first, properly check the transmission fluid level and condition. there's a procedure for that [not the same as motor oil].
if low, add, and find source of leak and repair.
if not low, you may have to go to 2 or more transmission specialists to get an estimate.
first, properly check the transmission fluid level and condition. there's a procedure for that [not the same as motor oil].
if low, add, and find source of leak and repair.
if not low, you may have to go to 2 or more transmission specialists to get an estimate.
Thread
Thread Starter
Forum
Replies
Last Post
AabirRizvi
ES - 1st to 4th Gen (1990-2006)
0
03-30-17 04:20 PM