Cruise Control Problem...
#2
No, but the computer does.
Connect TC & E1 in the DLC2 diagnostic port under the dash. The cruise control will flash the trouble code. Look that up in a factory service manual, or post the code<s> up here & we'll tell you what the code means.
Connect TC & E1 in the DLC2 diagnostic port under the dash. The cruise control will flash the trouble code. Look that up in a factory service manual, or post the code<s> up here & we'll tell you what the code means.
#4
Two ports in the DLC2 diagnostic port. Connect them with something conductive. I.E. shove a paperclip, or a wire to them. That puts the cruise control ECU into diagnostic mode.
Thread
Thread Starter
Forum
Replies
Last Post
dwebb99
SC- 1st Gen (1992-2000)
7
01-16-09 11:07 PM