Dogbone Mount
#1
Rookie
Thread Starter
Dogbone Mount
Easy to replace?
I'll probably get it from eBay, but if I need it sooner what's the part #?
It's the engine mount on the passenger side of the engine bay. Mine's torn where it mounts to the chassis.
97 ES
Thanks guys
I'll probably get it from eBay, but if I need it sooner what's the part #?
It's the engine mount on the passenger side of the engine bay. Mine's torn where it mounts to the chassis.
97 ES
Thanks guys
#2
Yes it's easy to replace. Get it off ebay, or rebuild it yourself.
It is not a time sensative device, I see no reason why it can't wait a few days for shipping, or a weekend project.
It is not a time sensative device, I see no reason why it can't wait a few days for shipping, or a weekend project.
#3
Rookie
Thread Starter
Originally Posted by Pheonix
Yes it's easy to replace. Get it off ebay, or rebuild it yourself.
It is not a time sensative device, I see no reason why it can't wait a few days for shipping, or a weekend project.
It is not a time sensative device, I see no reason why it can't wait a few days for shipping, or a weekend project.
How do I go about rebuilding the mount? I mean, it's obvious I just have to replace the rubber ring on the chassis side... but where would I find that?
#4
Lexus Connoisseur
Originally Posted by a13n0rma1
Time sensitive cause I'm selling the car.
How do I go about rebuilding the mount? I mean, it's obvious I just have to replace the rubber ring on the chassis side... but where would I find that?
How do I go about rebuilding the mount? I mean, it's obvious I just have to replace the rubber ring on the chassis side... but where would I find that?
#5
3M window weld (Poly Uerathane)
Bust the rubber out
Clean it
Refill with 3M
Let it setup 24 hours & replace it
You can make it really stuff by adding an ES bushing.
Otherwise, just buy one off ebay & remove the hardware so you can put it in. 14mm wrench is all you normally need.
Bust the rubber out
Clean it
Refill with 3M
Let it setup 24 hours & replace it
You can make it really stuff by adding an ES bushing.
Otherwise, just buy one off ebay & remove the hardware so you can put it in. 14mm wrench is all you normally need.
#6
Lexus Connoisseur
Good stuff.
Pheonix = Phoenix
Poly Uerathane = Polyurethane
Pheonix = Phoenix
Poly Uerathane = Polyurethane
Thread
Thread Starter
Forum
Replies
Last Post
pbbnxiltae
ES - 1st to 4th Gen (1990-2006)
11
11-10-07 06:34 AM