ES330/300 DIY (do-it-yourself) & technical tips
#91
It does not need to be a new remote, as long as it is the correct model for you car it should work. The programing procedure is used the get the reciever into a "learning mode" so that it will recognize the key fob transmitter as one that it should respond to.
#92
How to get headlights clean
people who have older cars have dirty headlights and they tried to wash it so many times but can never get it to be clear and shiny.
people who have older cars have dirty headlights and they tried to wash it so many times but can never get it to be clear and shiny.
Plastex also works
#96
Driver School Candidate
ES300714 -
The air filter should be basically behind the the dash on the bottom. If you reach near the gas pedal, you should be able to peel the carpeting up and see a slot where the air filter isnt, or you should be able to remove it. If you google around for air filter diagram it may be better able to show you
The air filter should be basically behind the the dash on the bottom. If you reach near the gas pedal, you should be able to peel the carpeting up and see a slot where the air filter isnt, or you should be able to remove it. If you google around for air filter diagram it may be better able to show you
The following users liked this post:
Fdavis13 (09-01-22)
#100
Driver School Candidate
Join Date: Aug 2011
Location: NY
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
motor mounts?
is there any write-ups to replace the motor mounts for the 3rd gen(97)? im getting a vibration at highway speeds, nothing at low speeds, front wheels balanced and alligned, no play in the wheels themselves, i should b looking at the motor mounts, yes?
#101
Lead Lap
iTrader: (1)
"How to Remove Stock Stereo Unit (PDF)" for the 97-01, no longer works. I found something similar here.
http://www.pro-fit-intl.com/Adobe/LX-51-92-p2.pdf
http://www.pro-fit-intl.com/Adobe/LX-51-92-p2.pdf
#102
Any info would be helpful.
#103
Driver School Candidate
Join Date: Jan 2008
Location: Delaware
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Sit in driver seat, driver door unlocked and open, all others closed and locked
manual open/close cycle 5 times each
close door
open door
manual open/close cycle
...then nothing. No automatic cycling by receiver to confirm it's in program mode.
I even tried cycling with the power locks the second time as some have suggested... still no automatic cycling to allow programming of the fob.
Anyone have any ideas? Much appreciated.
#104
Driver School Candidate
Join Date: Nov 2012
Location: CA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I have a 04 ES300, the door lock do not work with the key remote. Do I need to replace the complete actuator or is there just a motor or selenoid that can be replaced?