I just tried to debadge my 92 toyota windom only to find holes under the badges 4 under the windom 2 under the 30 g badge .
I will fill the holes from the underside of the boot lid.
are there any other windom quirks i need to know about ?
Here's the wiring diagram for the amplifier on the 92 - 96 ES300.
What you'll need to do is run speaker wires from your head unit to the corresponding speaker cable of the amplifier. Cut the speaker cable and connect it to the end that's not connected to the amplifier harness.
1994 ES300 Sold
2002 GS430 - NAV, MLS, GR2 w/Tiens spring, TTE 19s.
2003 GX470 - NAV, MLS, T4R 18s.
Sometimes the sun shines on a monkey's azz...I wonder when that azz would be mine.
how about the automatic window feature?? i had my ES broken into and the body shop never adjusted the window to stop in position at the top....so when the window closes it senses that theres something stopping it and it goes down as the obvious safety feature. thanks for the help
Newbie here working on my lady's 96 ES300. I'm a Modest Experienced DIY 911 Guy and decide to DIY hers.
I read a bunch of threads about the P0401 issue " EGR Flow Insufficient" and Cold Start Issue.
Tested the VMV (Vacuum Modulator Valve or Solenoid or Assembly) it would not hold a vacuum so I went to my local Toyota Dealer and bought the VMV for a 92 Camry Toyota Part #25870-62020 $105.48 (Parts Guy hooked me up and sold it for $80) Autozone had it for $78.99 shipped in 2 days. Other places sell them for $64 or $45 but you have to wait for it be shipped and not OEM.
Prior to this I took off the VMV and cleaned it out. Still had cold start issue but when warm it started right away. I reset the CEL but the CEL came back on after 10-15 miles.
Literally 5 mintues in the Dealer's parking lot (they were not too happy about that, but no one complained) and popped in the new VMV with a 10MM socket wrench, disconnected the battery. Bingo Trouble Code Gone, Started Right Up and running 100+ miles no issues.
Hello, I recently purchased a 96 ES 300 and the power antenna is broken. I bought an aftermarket assembly with red, green and black wires. Could someone provide some insight into getting it installed?
Thanks so much!
people who have older cars have dirty headlights and they tried to wash it so many times but can never get it to be clear and shiny.
This product is garbage. They didn't reply to 2-3 email inquiries so I figured, "what the heck, this headlight restoration kit is only $14.95, I'll give it a shot." I'll say 1% cleaner, but all in all a worthless product.
hi, just purchased an lsr performance chip, they claim to improve throttle response,gas mileage,shift quality,etc...the directions say to disconnect 2 wire iat or mat sensor and install this into connector..i dont have a iat or mat, just a air flow meter with a five wire connector..did you ever install one these? if so, do you know which wires need to be jumped, if at all possible? thank you..
Hi, my ES300 is a 94 model. It runs fine but the other day the od light began flashing and it will go into OD then kick out. Also sometimes 3rd will "slip" then kick back in. it was doing fine until the other day. I have been reading about the self diagnostic check by jumping the plug. How is this done on the 94 es300 I found a plug next to the fuse box. The speedometer still reads out fine so I didnt know if the speed sensor would act like this.
Last edited by tribalrabb; 12-26-08 at 12:17 AM..
Reason: add text