2nd-gen ES climate control light problem
#46
anyone with a 2000 ES300 have to enter a security code and/or get it from the dealership after disconnecting the radio? just want to be sure before i try this that i won't be held hostage to the tune of $100 or so just to get the factory security code from the stealership...
#49
Lexucanafer
#51
Pole Position
iTrader: (2)
need some info.????????
ok this is an old thread but has been very useful..thanx for that.
i wanted to know if i can change the color of the backlight in the climate control. does anyone know the size of the base on the leds? or better yet would i be able to use the bulbs in this link?????
http://www.superbrightleds.com/cgi-b...nstrument.html
any help, info or advise would be really great.
thanx again
i wanted to know if i can change the color of the backlight in the climate control. does anyone know the size of the base on the leds? or better yet would i be able to use the bulbs in this link?????
http://www.superbrightleds.com/cgi-b...nstrument.html
any help, info or advise would be really great.
thanx again
#53
Pole Position
iTrader: (2)
ok thanx... i called the dealer this morning....they dont have them in stock but can order them... $2.25 each plus tax and a $3.00 restocking fee per bulb...lol...so about $6 per bulb...6 bulbs in total... i used the parts # on the first page... i hope this isn't too hard to do....
#54
This morning I decided to try to take apart the A/C unit and see what's going on with the bulbs that don't light up the 'A/C', 'MODE' and defroster buttons. Thanks to Tom_ES300 and his stereo removal instructions here, I was off to a good start
Here's the stereo-and-A/C-unit cluster I took out.
Here's the stereo-and-A/C-unit cluster I took out.
#55
my scan/p scan and am/fm lights are out on my radio.....i'm guessing there soldered from what i read so my question is what size bulbs are they and anyway to get the right color? does the dealer sell them or are they aftermarket?
#56
Pole Position
iTrader: (2)
they are soldered in and the dealer doesn't sell the bulbs. your best bet would be to replace the cuircut board with the lights in it.....
http://parts.pioneerelectronics.com/...uctNum=CWM4320
http://parts.pioneerelectronics.com/...uctNum=CWM4320
#57
they are soldered in and the dealer doesn't sell the bulbs. your best bet would be to replace the cuircut board with the lights in it.....
http://parts.pioneerelectronics.com/...uctNum=CWM4320
http://parts.pioneerelectronics.com/...uctNum=CWM4320
#59
gotcha , thanks
one more question...on the fuel/trunk panel...those 2 lights are out on mine as well......i popped out the piece but it seems to be the whole switch and no bulb, is this right?
one more question...on the fuel/trunk panel...those 2 lights are out on mine as well......i popped out the piece but it seems to be the whole switch and no bulb, is this right?