transmission help need- code P0753
#1
Driver School Candidate
Thread Starter
Join Date: Mar 2013
Location: al
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
transmission help need- code P0753
I need help with trouble code P0753 for a 94 es300 transmission. I read a post a couple of days ago but now cannot find it. I think it will probably be better if I just start a new thread and check reply. I had the code pulled at Autozone tonight The code description is open or short circuit condition or Failed SSV SL1. Will I need to electrically test each solenoid to find the bad one or is SL1 the bad solenoid? Where can I get one without paying dealership price?
#2
Driver School Candidate
Join Date: Jan 2010
Location: CA
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
im having transmission problems as well but mine wont give me a CEL which is frustrating. atleast you have somewhere to start. looks like there isn't much support here on the ES side of the board.
#3
Lexus Champion
http://engine-codes.com/p0753_toyota.html
Probably a shift solenoid is not working properly, or it could be an external electrical fault.
Probably a shift solenoid is not working properly, or it could be an external electrical fault.
#5
Driver School Candidate
Thread Starter
Join Date: Mar 2013
Location: al
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
94 es 300
1. overdrive off light on dash blinking\
2. would not shift into low gear with shifter in drive or 2.
3. could manually shift in and out of low gear.
My best guess for your problem is a shift solenoid problem.
I looked on the door side panel and found the transmission type listed there. Using that info, I went to "cobra transmission" website and looked up the kit for my transmission. I recommend buying all the shift solenoids and the lock up solenoid and replacing them all at the same time. I think the price is right at $200 for all. Any good transmission shop can install them for you.
#6
Driver School Candidate
Join Date: Jan 2010
Location: CA
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
i tried doing a drop and fill. i used my compressor to blow it all out through the filler hole. i got alot of it out. i filled it back up with the toyota fluid and the noise wasn't there but it came back, just not as loud. i was able to drive it around with any issues. no jerking, no hard shifting. seems fine except for the buzzing. looks like im going to have to buy some solenoids. =/
#7
Driver School Candidate
Join Date: Jan 2010
Location: CA
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
my parts total for my U140E transmission is over $600 for ALL solenoids.
i didnt have a CEL but when i plugged in my scanner it did show P0770 - Shift Solenoid E
anyone know which solenoid i can buy instead of buying all?
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post