Chicago Area Installer for Coilovers/Alignment
10-13-10, 08:00 PM
#1
Driver School Candidate
Thread Starter
Join Date: Mar 2006
Location: IL
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Chicago Area Installer for Coilovers/Alignment
Anyone have any good recommendations for a shop that does good work and is reasonably priced to install my new BC Racing Coilovers on a Gen2 GS400. I also need to get an alignment afterwards - would be great if it was at the same place, but if not, looking for recommendations for that too. Thanks!
10-15-10, 10:56 PM
#3
Driver School Candidate
Thread Starter
Join Date: Mar 2006
Location: IL
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Thanks. I decided to tackle the job myself as I have a 4 post lift at home. Finished the front drivers side tonight and started on the drivers side rear. Broke two socket wrenches using an extension pipe trying to get the bottom suspension bolt off on the rear. been soaking in PB blaster too and still no luck. Will go to Sears in the morning and try again.
I really need an impact wrench, but only have a small 6 gallon pancake compressor - not sure that is enough. Tomorrow's going to be a long day.
Can't wait to get it done! Thanks again.
I really need an impact wrench, but only have a small 6 gallon pancake compressor - not sure that is enough. Tomorrow's going to be a long day.
Can't wait to get it done! Thanks again.
Where did you get this lift from?
Bottlefed installed my coilovers for me and have no issues