Welcome to my garage - and gaze upon my 1970 Chevelle!!
#18
Pole Position
Thread Starter
I was running the car without inner fenders for a while, but I do have some now that I plan to put on the car when it goes back together.. I may have to work them a bit for them meaty 275 front tires,we'll see on that too I suppose!
#20
Pole Position
Thread Starter
Found the cost to soda blast and powder the frame is just about $500, so I cant pass that up
Hows your Falcon project been going?
#21
Advanced
Project was moving along well but has been on hold for the past 6 months. We relocated back to Texas from Wisconsin and to a rental house with a smaller garage. We are working on a design for a new house to be built on land we purchased, but it will probably be February of next year before it is ready for move in. The new house will have a 4 car garage + shop so I will have plenty of room. Car funds have been diverted to house down payment funding but I still have parts that are ready to go on as soon as I find some time.
Here are a few pictures of the car just before we moved.
Here are a few pictures of the car just before we moved.
#22
Advanced
Don' want to thread jack. . . but. Quick details: 1965 Falcon Hardtop, original v8 car. Currently running full TCI protouring suspension front (A-arm) and back (3 triangulated 4-link) (used the kit intended for 65 mustang and modded to fit Falcon frame rails) 13" Wilwoods up front, 12"s out back. Wheels are ET III 18x8 up front with a 245 tire, 18x11 out back with a 315 tire. Hood custom made by me. Engine is 4.6 3v & 5 spd trans from an 06 mustang, plan to supercharge. End goal is 600+hp, 500+tq in a sub 3000lb car. Working on interior right now, have custom buckets to install, still need to work out the steering, and will install a 4 point cage.
#23
Pole Position
Thread Starter
Don' want to thread jack. . . but. Quick details: 1965 Falcon Hardtop, original v8 car. Currently running full TCI protouring suspension front (A-arm) and back (3 triangulated 4-link) (used the kit intended for 65 mustang and modded to fit Falcon frame rails) 13" Wilwoods up front, 12"s out back. Wheels are ET III 18x8 up front with a 245 tire, 18x11 out back with a 315 tire. Hood custom made by me. Engine is 4.6 3v & 5 spd trans from an 06 mustang, plan to supercharge. End goal is 600+hp, 500+tq in a sub 3000lb car. Working on interior right now, have custom buckets to install, still need to work out the steering, and will install a 4 point cage.
Thread
Thread Starter
Forum
Replies
Last Post