Lame SC3
#16
Driver
Thread Starter
i found the lip on sc page. Still have a little bit of filling to do as it was shipped cut in half. I have dyno sheets from the previous owner and it put down 265whp/256tq on a mustang dyno so I'm assuming about 300whp on a dynojet.
#17
Driver
Thread Starter
Previous owner who originally did the 1jz swap found me on facebook and gave me some info.
what he did when he did the swap was the following:
had the head sent out to get remachined, OE toyota head gasket, ARP head studs, and cam gears. He had a tweak'd wiring harness made and had Elite Auto in plainfield, Il install it. Here are some pictures he sent me when he had the car.
what he did when he did the swap was the following:
had the head sent out to get remachined, OE toyota head gasket, ARP head studs, and cam gears. He had a tweak'd wiring harness made and had Elite Auto in plainfield, Il install it. Here are some pictures he sent me when he had the car.
Thread
Thread Starter
Forum
Replies
Last Post
1siksc
SC- 1st Gen (1992-2000)
134
08-15-10 06:00 AM