Imprezario's Build - From Moscow With Mods )
#18
Lead Lap
Thread Starter
And here is the footbrake pedal from Altezza - The part number is 3132153010 and it looks like this:
Unfortunately, this part is not direct fit, some custom work is needed. Cut a metal plate and weld a bolt to it, insert the plate into the aluminum part from the back side, add washers and tighten the nut.
The result is a nice completed set of pedals - as it should be from the factory (sorry for the dirty floor mat)
Unfortunately, this part is not direct fit, some custom work is needed. Cut a metal plate and weld a bolt to it, insert the plate into the aluminum part from the back side, add washers and tighten the nut.
The result is a nice completed set of pedals - as it should be from the factory (sorry for the dirty floor mat)
#19
Lead Lap
Thread Starter
FINALLY, after FOUR months of waiting, my Medallion Touring exhaust and Strut tower bar from Tanabe have arrived!!!
Here are pics of unboxed Sustec Strut Tower Bar:
The weight of aluminum bar is pretty low )
Pics of exhaust will be posted soon.
Here are pics of unboxed Sustec Strut Tower Bar:
The weight of aluminum bar is pretty low )
Pics of exhaust will be posted soon.
#25
Lead Lap
Thread Starter
#27
Lead Lap
Thread Starter
My car is waiting for repair now, and another package from Japan has arrived - PIAA H-595 Tera Evolution T16 LED for reverse light. 6 LEDs in one bulb, 230 lm brightness, 6000k color. This LED will complete the PIAA-made exterior and interior lighting of the car.
Still Made In Japan )
Still Made In Japan )
Last edited by Imprezario; 03-06-15 at 01:54 AM.
#28
Car looks great!!!
I noticed you are dropped on Tein H Tech springs. Is that a .8 inch drop in front and .6 inch drop in rear?
Your car looks way lower than that for some reason. Any comments or opinions on your drop?
Thanks
I noticed you are dropped on Tein H Tech springs. Is that a .8 inch drop in front and .6 inch drop in rear?
Your car looks way lower than that for some reason. Any comments or opinions on your drop?
Thanks
#29
Lead Lap
Thread Starter
Yes, the springs are H Techs, but the are JDM -25 mm and -20 mm - lower than USDM ones, which give 0.8 and 0.6 inches of drop. TEIN doesn't offer S Techs in Japan for 3IS, so JDM H Techs are something between USDM H Techs and S Techs.
#30
Lead Lap
Thread Starter
Good news, the crash has not affected the body geometry - the broken parts just screwed off and replaced with the new ones. The car should ride like a new one after repair.
Meanwhile another box of small and nice parts is shipping from Japan - some of them will be the first on this forum )
Meanwhile another box of small and nice parts is shipping from Japan - some of them will be the first on this forum )
Last edited by Imprezario; 03-10-15 at 01:55 PM.