oldManTan

just a bit more modifying and it will be a tight squeeze, gonna wire them up and mold them in with fiberglass so it looks OEM, then i will print the lenses.

ThatSCguy

Any updates?

oldManTan

sorry, been too busy with work and financial stuff. probably in the spring i'll have updates. weather sucks and i can't work inside my parents house on the lights. once i move out i'll have updates.

oldManTan

i just don't have the time or the place for this anymore. i'm hoping to get an FRS as well to replace the SC so we'll see if i even finish this. sorry guys.

ThatSCguy

Sorry to hear that man. I believe you'll find the inspiration in yourself once again. Stay strong!

oldManTan

i'm actually back at it. just submitted a revision today. everything fits, i just wanna make some minor adjustments.
here's the fit, some trimming was done.







sorry for the awful lens, but it fits inside the lens

oldManTan

here's the model for anyone that is interested.
as you can see i stretched it quite a bit and just slimmed it down in general, i'm trying to bring the cost down of it now.

as you can see i moved the second beam over quite a bit, inside the light it was being blocked by the first light and also touching the lens with its top corner, which i want no contact at all with the lens unlike the stock headlight housing has.


i also rotated the entire piece around the mounting area, if you look back at the front facing photo, the 3D printed piece rises towards the right side because the angle of it was wrong, so i rotated it clockwise 2 degrees and you can see it compared to the flat reference line.


here is a top image showing how much more room is between the 2 pieces and the reduction of plastic in the middle.

tptpete

iTrader: (2)

Looks good!