KYLexusMkr Slow Base IS300awd Build thread
07-03-19, 05:26 PM
#1
Intermediate
Thread Starter
KYLexusMkr Slow Base IS300awd Build thread
Well here is my slow build thread. I’m new to the forum here as well as the Lexus brand. I am Toyota loyalist for maybe obvious or not so obvious reasons. Plans are to build my vehicle a little at a time, I purchased it new on July 4th of 2017 so you can see it has been just little here and there. So I figured I’d go ahead post the progress thus far.
Last edited by KYLexusMkr; 07-03-19 at 05:29 PM. Reason: Title change
07-03-19, 05:48 PM
#3
Intermediate
Thread Starter
As she sets now.
Mods thus far:
RR Racing ECU Tune
K&N Typhoon intake kit
JNC wheels Front 18X8 ET35 5mm spacer/Rear 18X9 ET32
”L” badges for center caps
Godspeed rear camber arms
AllFit 1.5” lip (temporary until I can find a better alternative I like on a base 300)
Non JDM vent visors w/chrome trim
Lexus wheel logos
International factory rear spoiler
17% tint all round
Future Mods:
Full exhaust, headers on back. Researching for the application that will fit my tastes.
Front and side splitters plus rear defuser after exhaust.
Lowering, not sure if I’m wanting springs or coil over system.
Wish list:
RR Racing Supercharger
(like it says...”Wish”)
😜
Last edited by KYLexusMkr; 07-14-19 at 04:14 AM. Reason: Added to list
The following users liked this post:
xcmoore (07-20-19)
07-14-19, 04:19 AM
#4
Intermediate
Thread Starter
“L” Center caps
K&N intake
All Fit lip, cheap but has saved me a few times so far on parking blocks and side walks.
Rear camber arm
Arm installed, not as hard as one would think with 19mm ratchet wrench, standard 19mm wrench, and some sockets.
Thread
Thread Starter
Forum
Replies
Last Post