blckbrd

My .02 on the pre cut sets
I ordered them as well for my F but they seemed too small upon inspection. I tried a million different ways and no luck. I called an installer recommended on the Lamin-X site to see if they could install the per cut film. They tried, but like I thought the film was about a half to one inch too small (at least). So I ended up having them do the install with a roll they had in stock. I never tried to get my money back on the per cut film sets I ordered from Lamin-X. I just chalked it up as another learning experience. If it looks too good to be true...
Anyway, these tail lights would've been a MFer!

Good luck

Rossi

iTrader: (4)

This looks like the tint for tail lights + the rear reflectors on is250.

QCisf

iTrader: (3)

Here's why I didn't bought the precut :s sorry for you bro

dorkacho

iTrader: (5)

although i think Rossi is right, it does look like they are for tails and rear reflectors..

dorkacho

iTrader: (5)

does it come off easy , say like, when you wash your car or something like that?

QCisf

iTrader: (3)

Nop ! Don't had this problem yet. But it's veryyyyy sticky so I don't think it will happen.

QCisf

iTrader: (3)

Will have to slow down the mods a little bit, just bought my first house Not so bad considering I'm only 21 years old haha. Can't wait to wash the F in the driveway every saturday morning !

torxuvin

Congrats!!! I'm 26, and I'm still working on my first. Condos are just so convenient around here ...uh can you make it over that lip to get into the garage though?

QCisf

iTrader: (3)

I will not be able to get into the garage until I got my paving stone driveway finished

dorkacho

iTrader: (5)

wow 21?! what do you do for a living :P that's a great mod congrats!!

QCisf

iTrader: (3)

Thanks bro I am an architectural technologist. I found the right job at the right time hahaha

usa5655

iTrader: (1)

great build!! where can i get those headlight films? gotta do this to my F

QCisf

iTrader: (3)

Lamin-X Check out post #73 to #96 if you want more info haha

Lmood

iTrader: (3)

What size sheets did you buy for the tails?

QCisf

iTrader: (3)

9"x30" did a perfect job!