jodc1012

Just got my Kranze Lxz rims and fit checked it and it's at least half inch out of the fender, front and rear . Will a fender roll fix this? What do you do with the bumper front and rear ? Does that just get stretch out and bolt on to the rolled fender..Help guy. Any suggestions. Thanks



Rear

Front

Keo

iTrader: (9)

Do you know the offset ? it sure pokes a bit

jodc1012

Yah it does poke a bit and plus the rim is just hanging with out the tire.

jodc1012

Offsets
front 35
rear 31

jodc1012

Actually it was not that bad. Rolled the fenders and pulled a bit.. looks good now..

Knarf916

Looks good. What kind of suspension ? I'm liking the ride height. Not to low, not too high.

jodc1012

Thanks. I got bc coilovers.

jodc1012

Thanks. I got bc coilovers. Spring rate 12 front aND 10 in rear.

VMRWheels

Nice, end result looks good! After putting it down on the ground, I'm sure the added negative camber helped a bit.

jodc1012

Thanks VMRWheels.. I did not add negative camber.. all natural camber. Just rolled rear fenders..