1999 Lexus GS300 from New Zealand!
#121
Intermediate
Thread Starter
#123
Intermediate
Thread Starter
The list is slowly reducing..
So previously the tyres for the rear wheels were not going to fit with the low that I want. I had these 225/35 left over from some other wheels so put them on. Stretch is probably more than I prefer but I didn't have to pay for them so... also yes the camber wear is bad haha; not ideal for driving.
Another thing today we fit up the Aimgain mufflers. I expected these to be straight bolt on but the shop ended up cutting and bending my factory exhaust a bit and you can see they're still not perfect. I'm not going to adjust them anymore as if I was going to go further with exhaust I would remove the tips completely and glass over the exhaust holes on the bumper so nothing there. A la Mercedes E series.
So I need to adjust the front lip now and re-fit the fog lights then drop the car for wrap.. we're getting close now !
So previously the tyres for the rear wheels were not going to fit with the low that I want. I had these 225/35 left over from some other wheels so put them on. Stretch is probably more than I prefer but I didn't have to pay for them so... also yes the camber wear is bad haha; not ideal for driving.
Another thing today we fit up the Aimgain mufflers. I expected these to be straight bolt on but the shop ended up cutting and bending my factory exhaust a bit and you can see they're still not perfect. I'm not going to adjust them anymore as if I was going to go further with exhaust I would remove the tips completely and glass over the exhaust holes on the bumper so nothing there. A la Mercedes E series.
So I need to adjust the front lip now and re-fit the fog lights then drop the car for wrap.. we're getting close now !
#125
Intermediate
Thread Starter
#126
Intermediate
Thread Starter
Did a little more trimming and fitted up the front lip with the fogs in it; wasn't too difficult.
Damage from front lip after only a couple of weeks haha. There is some special stone guard film that the wrap shop is going to put on the bottom for me to see if that helps a little!
Took a couple of potato pictures of the sample.. hard to tell really but it will look like this at the end..
So he will have that for a week or so, pretty flat out at the moment!
Damage from front lip after only a couple of weeks haha. There is some special stone guard film that the wrap shop is going to put on the bottom for me to see if that helps a little!
Took a couple of potato pictures of the sample.. hard to tell really but it will look like this at the end..
So he will have that for a week or so, pretty flat out at the moment!
#127
Lead Lap
iTrader: (3)
Another thing today we fit up the Aimgain mufflers. I expected these to be straight bolt on but the shop ended up cutting and bending my factory exhaust a bit and you can see they're still not perfect. I'm not going to adjust them anymore as if I was going to go further with exhaust I would remove the tips completely and glass over the exhaust holes on the bumper so nothing there. A la Mercedes E series.
!
!
rooting for u boss!
#128
Intermediate
Thread Starter
If you end up not being able to tuck the tipps up in there in the cutouts and go the glassing over the cutouts routs, might i suggest fabbing up the bumper to allow a side exit exhaust?...would be tough. Just throwing an idea at you. But as mentioned above, you ought to be able to get them tucked up in there snug...once you do though, be forwarned those heat sheilds up in there can cause a nasty vibration. i keep a rubber mallet in my trunk to keep the buzzing away lol
rooting for u boss!
rooting for u boss!
#130
Intermediate
Thread Starter
#132
Intermediate
Thread Starter
#134
Intermediate
Thread Starter
#135