CatManD3W SC300 Ongoing Build...
02-23-14, 11:15 AM
#65
Yes I am going to be replacing all of the above you mentioned(HG, Water Pump,Oil Pump, Valve seals, Rear main seal...etc) I have purchased the complete 2jzgte gasket kit....I also have a set of ARP head studs to install as well..
Last edited by CatManD3W; 02-23-14 at 11:19 AM.
02-23-14, 02:29 PM
#67
1JZ Single SC400
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
I made my work bench about the same height. Makes more sense to make room underneath and keep your back from hurting from looking down so much. Glad you liked my wrapping job on the studs. LOL
02-23-14, 03:29 PM
#68
02-25-14, 09:56 AM
#70
Waiting for parts to get here....
Did manage to get the engine put on the engine stand.....Was a little surprised on how high it was
Also for those of you who are looking or wondering what bolts to use here are the specs M12x1.25x80 (12mm bolt size, thread pitch of 1.25 and length of 80mm)
I also picked up some washers to space it out...3 on each bolt worked perfect
Added a some extra support in the front as a precaution...The stand is rated for 1000lbs but I feel better with the 2x4 in the front
Did manage to get the engine put on the engine stand.....Was a little surprised on how high it was
Also for those of you who are looking or wondering what bolts to use here are the specs M12x1.25x80 (12mm bolt size, thread pitch of 1.25 and length of 80mm)
I also picked up some washers to space it out...3 on each bolt worked perfect
Added a some extra support in the front as a precaution...The stand is rated for 1000lbs but I feel better with the 2x4 in the front
