Sc drift build
03-04-13, 02:15 PM
#20
Rookie
Thread Starter
iTrader: (2)
Join Date: Mar 2013
Location: Or
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
How much? Those are the ones I was going to get from driftmotion. Ya my last tube front on my 240 I left them open and I got so much crap in my engine bay, and in oregon it tends to rain and I don't want my filter getting wet.
03-04-13, 02:51 PM
#22
Rookie
Thread Starter
iTrader: (2)
Join Date: Mar 2013
Location: Or
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Ok I wasn't planning on ordering them for a weeks but ill let you know and see if you still have them. I also have a parts car that might have something you need. I think I'm going to make my own knuckles the sc's are actually pretty easy looking compared to a s13. My friend zack abracrombie makes awesome angle kits he made 73 degrees and the FC rx7. Close to to 70 in the 240. He is going sometime soon start making a kit for the sc if he can get cought up on orders. Which ill post all te info when that kits done. But for know I'm going going to mess around with my extra knuckles I have
03-04-13, 09:21 PM
#23
Rookie
Thread Starter
iTrader: (2)
Join Date: Mar 2013
Location: Or
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
The ecu I got lol. Whoever extended this harness left it about 3 inches short when they did it so the harness barely reaches down past the heater box. I'm going to have to extend it again
03-05-13, 07:50 AM
#24
Pole Position
trades can be made for sure! im not really in a selling mood, I really could use a set of fenders if the price is right. no problem let em know via PM and we can make a deal
03-07-13, 04:27 PM
#25
Lead Lap
iTrader: (1)
Join Date: Oct 2011
Location: az
Posts: 532
Likes: 0
Received 0 Likes
on
0 Posts
Ok I wasn't planning on ordering them for a weeks but ill let you know and see if you still have them. I also have a parts car that might have something you need. I think I'm going to make my own knuckles the sc's are actually pretty easy looking compared to a s13. My friend zack abracrombie makes awesome angle kits he made 73 degrees and the FC rx7. Close to to 70 in the 240. He is going sometime soon start making a kit for the sc if he can get cought up on orders. Which ill post all te info when that kits done. But for know I'm going going to mess around with my extra knuckles I have
03-07-13, 07:47 PM
#27
Rookie
Thread Starter
iTrader: (2)
Join Date: Mar 2013
Location: Or
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
I have a question if someone can help I have this 2 wire plug coming off the harness that comes out of the timing cover right where the o2 wires come out, and the plug has been lengthened by about 5ft and im not sure where it goes.
