1JZPWRD

iTrader: (59)

Looks like a great project build man. I am subscribed. Check out mine in my signature!

stockhatch

iTrader: (12)

Chaser fo sho. I hope you got that motor cheap because you have plenty of extra wiring, sump swapping, pump and fan swapping to do. Good luck with it sir!

Luv2xl

iTrader: (5)

ECU wiring will be fine...

Good luck wih the install. Don't cut corners and replace the seals, maintenance items... Good luck!

INTIMAZY

iTrader: (5)

Is that a 300zx I see in the background? It looks like a good candidate for swap

kez

iTrader: (4)

Are you they pep boys guy?
And yes it is a 300zx after the 1jay is swapped over the old 2jz-ge will be the new heart of the Z Na-t of course. And I'll prob put the daily 1988 300zx in garage restore that baby

megamax

iTrader: (9)

well i got the exact same motor swap from engine depot. and yes yours is from a chaser..

JDMb16bEG6

Lol yup pep boys bro, I think I remember you, black sc, did you auto to manual swap, then did a head gasket?

kez

iTrader: (4)

yeah you'll be getting pm's

yupp that's me

JDMb16bEG6

That's what's up bro, let me know if you need a hand, I'm still in the process of collecting parts and extending the harness, I was lucky enough to get a 1jz vvti out of a soarer, let me know bro, always down to work on an sc

kez

iTrader: (4)

Little baby update ive been doing alot of research but oil pans are off until my package comes from driftmotion


couple of questions what did you guys block off the stock blow off valve with? or do i have to get creative and make it

StiCk3

iTrader: (5)

^^ If you know how to weld or know someone who does, you can cap off the old BOV holes. i talked with a guy at work who does welding on the side, he said he could weld the old BOV holes shut on mine no problem. Will be going this route later in life

meangreen1

iTrader: (13)

You should do the rear main while its open.

kez

iTrader: (4)

I'm looking at the oil drain neck in the last pic. Does this mat directly to my 2jzge rear sump oil pan?

StiCk3

iTrader: (5)

^^ it should, but remember you need to drill out your old 2J pan and tap the two bolt holes on the upper portion of the pan. Should work though

levie

iTrader: (1)

subscribed, good luck!