9aristo

iTrader: (10)

Custom Exhaust System:

Resulting system after 5 attempts. First attempt - straight pipes right after primary cats. Too loud. Second attempt - straight pipes after secondary cats. Still too loud. Third attempt - added center resonator, straight pipes after (essentially stock system without mufflers). Drones under 2000 rpm. Fourth attempt - removed center resonator, added both stock mufflers (at this point, it's essentially stock system without resonator and crush pipe at the axle). Too quiet. This system (the Goldilocks moment) - straight pipes after secondary cats, removed resonator and stock mufflers, and 2 Magnaflow mufflers at the end. Area facing bumper diffuser painted flat black.

This is effectively a catback system with straight pipes/skilled mandrel bends (google!) and two Magnaflow mufflers. No x-pipe was chosen as I was mirroring Joe-Z/ Borla. Sufficient amount of flow for the V8 to gurgle at idle and wail at high engine speed. Reasonably quiet under light/ moderate load. Consider it the middle ground between Joe-Z and Borla. If it's too tame, you can always run this before the secondary cats, but it might drone. San Gabriel PD approved!

$250 o.b.o

Local pick up in the 626 area. Exhaust system is pretty hard to haul - will assist in hauling it to a shop of your choice within reasonable distance and haul your stock system (within reasonable distance) back to your place.

(323)999-1184
text preferred

boredpnoy

inboxed for the door sills

Navydoc13

hows the fit on that spoiler?

9aristo

iTrader: (10)

roof spoiler, trunk spoiler, door sills and floor mats sold locally (practically everything that was useable for is250/350)

exhaust and fog light covers set are only items left (ISF only)

I had the stock ISF spoiler but I for the life of me can't find it or else it'd be on here.

please feel free to pitch an offer, need this stuff gone!!!

projectdna

iTrader: (56)

might be interested in the fog light covers. are they easy to install/remove?

9aristo

iTrader: (10)

They snap onto the bumper with 4 integrated clips -just a matter of pulling the covers out straight and firmly.

Exhaust just need to be welded on, local shop here usually charges 60 bucks.

Meraki Autoworks

iTrader: (8)

if you let me install the lights I'm interested haha.

Meraki Autoworks

iTrader: (8)

or the fog light covers,

9aristo

iTrader: (10)

need this exhaust off the bed of my tundra! any offers? assisting with hauling your exhaust(s) around!

vintage

iTrader: (6)

I want the fog light surrounds if they are clean and not worn...... I can't tell from the pic
I have the same material but didn't have Any success wrapping mine

9aristo

iTrader: (10)

keeping it local for now. I had issues too - but after trial and error and a whole 2 by 4 feet sheet later, it can be done. You just need heat - none of that pansy hairdryer heat. you need a heat gun, feels like the back of a jet engine heat.

fog light covers have been spoken for.

come on ppl take this cat back exhaust system off my hands. would it be more tempting if I made it bolt on?

rselby

what kind of projectors are those that you retrofitted for the fog lights, what bulb size , and how much shipped to 32257

9aristo

iTrader: (10)

those aren't for sale!

those are the fog lights from the ford fusion - with removed foreground limiter shields and modified cutoff shields. uses H11 bulbs.

9aristo

iTrader: (10)

$250 o.b.o?

9aristo

iTrader: (10)

/sneeze /bump