CA FS: *Protype* Carbon Engine Cover
10-26-09, 03:55 PM
#1
Lexus Test Driver
Thread Starter
iTrader: (7)
Join Date: Feb 2002
Location: ( . )( . )
Posts: 1,231
Likes: 0
Received 0 Likes
on
0 Posts
FS: *Protype* Carbon Engine Cover
Item: Carbon Fiber Engine Cover
Detail: Prototype, needs to glue-in your stock rubber connectors on the back side.
Condition: Mint, besides the minor cracks on the edge which can be smoked for invincibility.
Location: SoCal
SOLD AS IS to Vintage, UPS tracking # has been forwarded through PM.
Pictures:
Detail: Prototype, needs to glue-in your stock rubber connectors on the back side.
Condition: Mint, besides the minor cracks on the edge which can be smoked for invincibility.
Location: SoCal
SOLD AS IS to Vintage, UPS tracking # has been forwarded through PM.
Pictures:
Last edited by IS300eR; 01-09-10 at 12:32 AM.
10-29-09, 12:57 AM
#4
Lexus Test Driver
Thread Starter
iTrader: (7)
Join Date: Feb 2002
Location: ( . )( . )
Posts: 1,231
Likes: 0
Received 0 Likes
on
0 Posts
Ofcourse not, I'll pack it real nice with bubbles/peanuts for better cushion to prevent it from being damanged from shipping. 
I think it already has a layer of clear on it base on its glossy-ness, but a re-coat of clear is highly recommanded; but from what I see, just smoke the edge (or touch it up with resin, if that's a way to fix the blemish on the edge), switch the rubber fittings from the stock hood, and this should be good to go!
I think it already has a layer of clear on it base on its glossy-ness, but a re-coat of clear is highly recommanded; but from what I see, just smoke the edge (or touch it up with resin, if that's a way to fix the blemish on the edge), switch the rubber fittings from the stock hood, and this should be good to go!
