MD AAP TH400 tranny and Gear Vendor OD unit
#1
AAP TH400 tranny and Gear Vendor OD unit
Im selling my AAP stage 5 TH400 set up with Pro Torque 3200 stall converter. The tranny literally has less than 600 street miles on it, no track runs, one dyno session.
Comes with the tranny, tq converter, adapter plate, B&M tranny cooler, B&M Hammer shifter, driveshaft (shortened for GV unit), and poly tranny mount.
Im selling it for $2600.......which is about half of what I paid for it.
I also have a Gear Vendors OD unit with all of the supporting electronics for sale. Same as the tranny, it has less than 200 miles on it and works flawlessly. I paid $2600 plus shipping for this new. I will sell it for $2000 shipped.
All of these items are like new. Only reason im selling is to convert to the V160 set up.
Comes with the tranny, tq converter, adapter plate, B&M tranny cooler, B&M Hammer shifter, driveshaft (shortened for GV unit), and poly tranny mount.
Im selling it for $2600.......which is about half of what I paid for it.
I also have a Gear Vendors OD unit with all of the supporting electronics for sale. Same as the tranny, it has less than 200 miles on it and works flawlessly. I paid $2600 plus shipping for this new. I will sell it for $2000 shipped.
All of these items are like new. Only reason im selling is to convert to the V160 set up.
#2
you had this on a gs400 motor correct? What kind of power is this trans good for? reverse pattern? What bell housing did you use? what would be needed to bolt it up to a gte block? is the drive shaft an oem unit that was shortened or is it an aftermarket driveshaft? thanks in advance!
Thread
Thread Starter
Forum
Replies
Last Post
TTurboPimp
2Gen GS430 / 400/ 300 Classifieds (98-05)
2
08-21-09 01:47 PM
TTurboPimp
2Gen GS430 / 400/ 300 Classifieds (98-05)
1
12-30-05 05:05 PM