TX FS: Custom Fabricated Turbo Manifold Collector + 2JZ-GTE Exhaust Flange + T4 Flange
09-16-09, 11:29 PM
#1
FS: Custom Fabricated Turbo Manifold Collector + 2JZ-GTE Exhaust Flange + T4 Flange
Another one of my projects that I wish I had time to finish, but just unfortunately don't at the moment. Selling off some of my experimentation. If anyone here wants a go at fabricating a custom turbo manifold or take these to a shop to cut down on labor hours. The collector is built out of 1.5" diameter schedule10 stainless 304 pipe. This is some seriously heavy duty stuff! A 6ft straight pipe of it weighs in at around 15lbs or so!
The exhaust flange is stainless 1/2" thick, t4 flange is 3/8" thick stainless. The collector is tig welded by me and then ground down to smooth the flow inside.
Selling all for $220 shipped.
Or
$150 for collector and $100 for 2JZ-GTE flange + T4 flange
The exhaust flange is stainless 1/2" thick, t4 flange is 3/8" thick stainless. The collector is tig welded by me and then ground down to smooth the flow inside.
Selling all for $220 shipped.
Or
$150 for collector and $100 for 2JZ-GTE flange + T4 flange
Last edited by JeffTsai; 09-16-09 at 11:33 PM.
Thread
Thread Starter
Forum
Replies
Last Post
soarer8o8
SC400 / 300 Classifieds
6
03-14-14 08:37 PM
djkevin510
SC400 / 300 Classifieds
3
01-21-10 02:57 AM
