TX FS: Custom charge pipe with SSQV & AIT flange
#1
FS: Custom charge pipe with SSQV & AIT flange
Selling the custom charge pipe I welded up for my car. I went with a twin BOV setup and relocated both the BOV's into the bumper, so I no longer need this pipe. The pipe is made of stainless steel. There is also a 3/8NPT bung welded on for use with the GM air intake temp sensor(for standalones). It also has a 1/8NPT hole tapped near the bottom which was used for my water/methanol injection setup. This pipe has also been chrome ceramic coated so in addition to keepin the heat out, it will keep that nice shine and will not dull out like polished aluminum. The ends of the pipe also have welded on beads to prevent the couplers from popping off when running very high boost.
The BOV and AIT sensor IS NOT included. Selling this pipe for $50 shipped.
Here's a picture of what it looked like in my car.
The BOV and AIT sensor IS NOT included. Selling this pipe for $50 shipped.
Here's a picture of what it looked like in my car.
#2
Bump, someone make me an offer if you want it. I think $50 is a reasonable price factoring in the price of the BOV flange, IAT flange, stainless pipe itself, and the ceramic coating which was about $25 alone. If you're doing a GTE swap then this will be a good alternative rather than to have one custom fabricated at a much higher price.
Thread
Thread Starter
Forum
Replies
Last Post