FS: SRT 2.5 Headgasket, RC 440 injectors, 3" downpipe, 4" intake pipe - ALL brand new
12-20-07, 07:32 AM
#1
FS: GTE Internals, SRT 2.5mm Headgasket, Tial WG springs, custom exhaust
1. Toyota GTE internals, new unused - pistons, rings, bearings, rods.
I think I'm going to purchase a GTE block and need these gone. Nothing to hide here, brand new GTE internals ready to go! $600 shipped, OBO.
2. SRT 2.5mm Headgaset, brand new/unused. Building my GE block so I no longer need a 2.5 hg. $220 shipped, OBO
3. Wastegate dump tube. Brand new, looks to be the mainstream ebay version, square flange for larger wg. $25 shipped
4. Tial Wastegate Springs. 1 4psi small yellow spring and 1 7psi small green spring. MINT $20 each shipped
5. 4ply Silicone Couplers. High quality from boostcontroller, NOT ebay rubber. Blue in color. 1 3" and 1 2.5" x 2.75"$10 each shipped, OBO
6. Custom 2.5" axle back muffler with less then 100miles of use. 2.5" nonbaffled free flowing muffler, brand is unknown but the polished stainless finish is nice despite sitting in my garage for some time. Tip is 4.5" and piping is crush bent. Sounded very nice- not loud by any means but a mild deep tone when getting on the throttle. This was orginally on a straight bpipe eliminating the oem bpipe..the cut is somewhere in between (longer then then axle back, not long enough to replace bpipe portion - see comparison pic below). $100 shipped
7. SOLD RC 440cc injectors. Look to be brand new, flow tested and all are within 1%. High Impedance, p/n SL4-440, drop in fit for IS300. SOLD
8. SOLD 3" downpipe. Brand new, looks to be the mainstream ebay version...welds look good. SOLD
9. SOLD 4" intake pipe. Brand new, looks to be the mainstream ebay version...welds look great. SOLD
GTE internals
SRT 2.5mm HG
3" dp, 4" intake pipe, WG dump tube
Tial WG yellow spring...green looks the same only green.
2.5" Exhaust
Length compared to oem is300 exhaust:
I think I'm going to purchase a GTE block and need these gone. Nothing to hide here, brand new GTE internals ready to go! $600 shipped, OBO.
2. SRT 2.5mm Headgaset, brand new/unused. Building my GE block so I no longer need a 2.5 hg. $220 shipped, OBO
3. Wastegate dump tube. Brand new, looks to be the mainstream ebay version, square flange for larger wg. $25 shipped
4. Tial Wastegate Springs. 1 4psi small yellow spring and 1 7psi small green spring. MINT $20 each shipped
5. 4ply Silicone Couplers. High quality from boostcontroller, NOT ebay rubber. Blue in color. 1 3" and 1 2.5" x 2.75"$10 each shipped, OBO
6. Custom 2.5" axle back muffler with less then 100miles of use. 2.5" nonbaffled free flowing muffler, brand is unknown but the polished stainless finish is nice despite sitting in my garage for some time. Tip is 4.5" and piping is crush bent. Sounded very nice- not loud by any means but a mild deep tone when getting on the throttle. This was orginally on a straight bpipe eliminating the oem bpipe..the cut is somewhere in between (longer then then axle back, not long enough to replace bpipe portion - see comparison pic below). $100 shipped
7. SOLD RC 440cc injectors. Look to be brand new, flow tested and all are within 1%. High Impedance, p/n SL4-440, drop in fit for IS300. SOLD
8. SOLD 3" downpipe. Brand new, looks to be the mainstream ebay version...welds look good. SOLD
9. SOLD 4" intake pipe. Brand new, looks to be the mainstream ebay version...welds look great. SOLD
GTE internals
SRT 2.5mm HG
3" dp, 4" intake pipe, WG dump tube
Tial WG yellow spring...green looks the same only green.
2.5" Exhaust
Length compared to oem is300 exhaust:
Last edited by mikellucci; 01-07-08 at 06:52 AM.
